ADC calibration scheme and algorithm are not changed. Only the eFuse bit BLOCK1_VERSION is changed. This MR updated the logic to recognize the adc efuse version
Add TRY_ENTRY_CRITICAL() API to all for timeouts when entering critical sections.
The following port API were added:
- portTRY_ENTER_CRITICAL()
- portTRY_ENTER_CRITICAL_ISR()
- portTRY_ENTER_CRITICAL_SAFE()
Deprecated legacy spinlock API in favor of spinlock.h. The following API were deprecated:
- vPortCPUInitializeMutex()
- vPortCPUAcquireMutex()
- vPortCPUAcquireMutexTimeout()
- vPortCPUReleaseMutex()
Other Changes:
- Added portMUX_INITIALIZE() to replace vPortCPUInitializeMutex()
- The assembly of the critical section functions ends up being about 50 instructions longer,
thus the spinlock test pass threshold had to be increased to account for the extra runtime.
Closes https://github.com/espressif/esp-idf/issues/5301
peripheral enable/disable usually should be managed by driver itself,
so make it as espressif private APIs, not recommended for user to use it
in application code.
However, if user want to re-write the driver or ports to other platform,
this is still possible by including the header in this way:
"esp_private/peripheral_ctrl.h"
For some of the MSPI high frequency setting (e.g. 80M DDR mode Flash or PSRAM), timing tuning is required.
Certain delays will be added to the MSPI RX direction. When system clock switches down, the delays should be
cleared. When system clock switches up, the delays should be restored.
External memory is accessed via SPI0. When modifying the SPI0 registers,
should put the code in internal RAM. Otherwise when there is an ongoing
SPI0 transaction, CPU changes the SPI0 registers. This is dangerous.
Besides, modifying SPI0 registers may lead external memory to an
unstable state. Therefore putting these code in internal RAM is
necessary.
When doing OCode self-calibration in rtc_init.c, it will change the
system clock from PLL to XTAL, which is in a lower frequency, and MSPI
timing tuning is not needed. Therefore we should modify the timing
configurations accordingly, and set it back after the calibration.
This is a temporary fix
When the application is being debugged it should check the call result (esp_cpu_in_ocd_debug_mode())
is not given volt.glitch attack - so the result is triple-checked by ESP_FAULT_ASSERT macro. In case
the check fails, the system is reset immediately
IDF-4014
