In c4bcf111, soc_memory_types.h header was moved from soc to
esp_hw_support. Since some of the functions are also used in
bootloader and because esp_hw_support is not part of the bootloader
build, part of the functions were moved into bootloader_support.
To make these functions available to the app, bootloader_support was
added as a public dependency of esp_hw_support.
Since esp_hw_support is in common requirements list, this has added
bootloader_support as a public requirement to every component in the
build. Adding new public requirements outside of common components
is undesirable, since components may accidentally include headers
from bootloader_support without explicitly declaring it as a
requirement.
This commit reverts this addition. Until a better solution is found,
some part of esp_memory_utils.h is duplicated into
bootloader_memory_utils.h. A CI check is added to make sure these
files stay in sync.
ESP32-S2 and ESP32-S3
supports up to 1 GB of external flash and RAM
add support for
- 32MB
- 64MB
- 128MB ( example NOR spiFLASH 1G-BIT W25Q01JVZEIQ Winbond 0xEF 0x40 0x21 )
Merges https://github.com/espressif/esp-idf/pull/7688
Signed-off-by: Ivan Grokhotkov <ivan@espressif.com>
- Add to docs & config descriptions
- Change to a "choice" to become self-documenting
- Keep the bootloader_common_check_long_hold_gpio() function for compatibility
Updates the following with changes from verification branches:
* esp_rom linker files
* rtc_cntl and system reg and struct headers
Also updates:
* GDMA driver with new register layout
* esptool submodule commit
Additionally, always enable the partition MD5 check if flash encryption is on in
Release mode. This ensures the partition table ciphertext has not been modified
(CVE-2021-27926).
The exception is pre-V3.1 ESP-IDF bootloaders and partition tables, which
don't have support for the MD5 entry.
As this mode uses the public keys attached to the existing app's signatures to
verify the next app, checking that a signature block is found on boot prevents
the possibility of deploying a non-updatable device from the factory.
ESP32 V1 and V2 - protection bits.
ESP32xx V2: revoke bits, protection bits
- refactor efuse component
- adds some APIs for esp32 chips as well as for esp32xx chips
Sometimes the flash size read from bootloader is not correct. This may
forbid SPI Flash driver from reading the the area larger than the size
in bootloader header.
When the new config option is enabled, the latest configured
ESPTOOLPY_FLAHSIZE in the app header will be used to override the value
read from bootloader header.
Allows booting in QIO/QOUT mode or with PSRAM on ESP32-PICO-V3 and
ESP32-PICO-V3-O2 without any config changes.
Custom WP pins (needed for fully custom circuit boards) should still be compatible.
