1. mem_burst_length register field correction
2. remove dma buffer addr range restriction
3. M2M periph sel ID no need to be identical for TX and RX channels
4. correct rx descriptor owner field auto clear
5. remove fsm idle assertion for ERR_EOF
feat(esp_hw_support): esp32p4 sleep support (Stage 1: support basic pmu sleep function 💤)
Closes IDF-7528 and IDF-7527
See merge request espressif/esp-idf!28196
There is no separate permission control peripheral in C6/H2/P4.
Memory protection is achieved using built-in PMA/PMP and hence
removing permission control specific files.
- modify console example to use the new SOC_LIGHT_SLEEP_SUPPORTED
and SOC_DEEP_SLEEP_SUPPORTED macros when registering sleep commands
- remove exclusion of esp32p4 in basic and advanced example in
.build-test-rules.yml
- replace exclusion of esp32p4 for deep and light sleep tests with newly introduced macro
- remove the temporary disable check for esp32p4 and uses the
SOC_LIGHT_SLEEP_SUPPORTED maccro instead.
This commit introduce SOC_MEM_NON_CONTIGUOUS_SRAM flag (that enebled for
esp32p4). If SOC_MEM_NON_CONTIGUOUS_SRAM is enabled:
- LDFLAGS+=--enable-non-contiguous-regions
- ldgen.py replaces "arrays[*]" from sections.ld.in with objects under
SURROUND keyword. (e.g. from linker.lf: data -> dram0_data SURROUND(foo))
- "mapping[*]" - refers to all other data
If SOC_MEM_NON_CONTIGUOUS_SRAM, sections.ld.in file should contain at
least one block of code like this (otherwise it does not make sense):
.dram0.bss (NOLOAD) :
{
arrays[dram0_bss]
mapping[dram0_bss]
} > sram_low
.dram1.bss (NOLOAD) :
{
/* do not place here arrays[dram0_bss] because it may be splited
* between segments */
mapping[dram0_bss]
} > sram_high
Increase LP_UART_EMPTY_THRESH_DEFAULT value to 4. The original value
could cause the FIFO become empty before filling next data into the FIFO
when the buadrate is high. TX_DONE interrupt would raise before actual
transmission complete in such case.
For C6/H2/P4/C5, there is no SoC specific debug range. Instead the same
address range is part of CPU Subsystem range which contains debug mode
specific code and interrupt config registers (CLINT, PLIC etc.).
For now the PMP entry is provided with RWX permission for both machine
and user mode but we can save this entry and allow the access to only
machine mode for this range.
For P4/C5 case, this PMP entry can have RW permission as the debug mode
specific code is not present in this memory range.
