liuning
3fa9c578f9
fix(clk): clear all lpclk source at clk init
2024-02-07 13:49:18 +08:00
Marius Vikhammer
06850e0e1e
refactor(system): removed esp_system from astyle ignore list and reformated it
2024-01-30 15:17:15 +08:00
Song Ruo Jing
cf93777077
refactor(rtc): move soc/rtc.h from soc to esp_hw_support component
...
Deprecated rtc_xtal_freq_t, replaced with soc_xtal_freq_t defined in
clk_tree_defs.h in soc component.
2024-01-25 19:15:33 +08:00
Cao Sen Miao
6768805d20
fix(uart,usj...): Fix wrong serial number that has been parsed to rom functions,
...
Closes https://github.com/espressif/esp-idf/issues/12958
2024-01-18 10:51:51 +08:00
fl0wl0w
d149c1b26f
Use configuration option instead of in components not related to FreeRTOS
...
Mergeshttps://github.com/espressif/esp-idf/pull/12481
2023-11-28 07:49:20 +00:00
morris
71cf16ec01
feat(gptimer): use RCC atomic block to enable/reset peripheral
2023-08-22 17:05:35 +08:00
Gustavo Henrique Nihei
3cbac3dd1d
esp_system: Ensure TIMG0 clock is always enabled during normal operation
...
If the TimerGroup 0 clock is disabled and then reenabled, the watchdog
registers (Flashboot protection included) will be re-enabled, and some
seconds later, will trigger an unintended reset.
Signed-off-by: Gustavo Henrique Nihei <gustavo.nihei@espressif.com>
2023-03-06 04:58:11 +00:00
Li Shuai
526a9c665a
backup dma: force clear reset signal to fix the backup dma operation failure caused by RTC_SW_CPU_RST
2022-10-20 03:24:49 +00:00
jingli
60c1811433
esp_hw_support/clk_cali: remove redundant check for cali value
2022-09-21 03:03:25 +00:00
Guillaume Souchere
6005cc9163
hal: Deprecate interrupt_controller_hal.h, cpu_hal.h and cpu_ll.h interfaces
...
This commit marks all functions in interrupt_controller_hal.h, cpu_ll.h and cpu_hal.h as deprecated.
Users should use functions from esp_cpu.h instead.
2022-07-22 00:06:06 +08:00
wangmengyang
1d55f12c2d
component/bt: reset Bluetooth hardware during controller inititalization on ESP32-C3/ESP32-S3
...
1. Rename MACROs SYSTEM_WIFI_RST_EN register bit fields to be more recognizable
2. reset Bluetooth baseband and clock bits to fix the issue of task watchdog triggered during controller initialization due to invalid hardware state
2022-07-06 16:23:48 +08:00
songruojing
03477a59db
rtc_clk: Fix rtc8m calibration failure after cpu/core reset
...
1. make sure 8md256 clk is enabled before calibration
2. improve bootloader and application startup 8m, 8md256 enable logic
2022-06-13 17:47:51 +08:00
KonstantinKondrashov
ac4c7d99fe
dport: Move DPORT workaround to G0
2022-05-31 13:44:18 +08:00
songruojing
a5b09cf015
rtc_clk: Clean up some clock related enum and macro in soc/rtc.h, replace with new ones in
...
soc/clk_tree_defs.h
2022-05-24 22:59:41 +08:00
Marius Vikhammer
d2872095f9
soc: moved kconfig options out of the target component.
...
Moved the following kconfig options out of the target component:
* CONFIG_ESP*_DEFAULT_CPU_FREQ* -> esp_system
* ESP*_REV_MIN -> esp_hw_support
* ESP*_TIME_SYSCALL -> newlib
* ESP*_RTC_* -> esp_hw_support
Where applicable these target specific konfig names were merged into
a single common config, e.g;
CONFIG_ESP*_DEFAULT_CPU_FREQ -> CONFIG_ESP_DEFAULT_CPU_FREQ_MHZ
2022-04-21 12:09:43 +08:00
Ivan Grokhotkov
c70a69b1dd
Merge branch 'bugfix/remove_ref_non_ex_options' into 'master'
...
config: removed references to non-existing kconfig options
See merge request espressif/esp-idf!17495
2022-03-25 18:02:54 +08:00
Marius Vikhammer
0fbae992dd
config: removed references to non-existing kconfig options
2022-03-15 18:32:22 +08:00
Marius Vikhammer
ca3c056ac9
kconfig: replace deprecated options with new values
2022-03-15 16:28:53 +08:00
songruojing
c1dedb33fa
esp_system: replace the range comparsion for reset reason in perip clk init with specific reset reason check, also add a test case in LEDC to check for the perip clk not being disabled after cpu reset
2022-02-09 15:54:34 +08:00
Cao Sen Miao
eddc196081
esp_clk: refactor target/clk.h to private/esp_clk.h
2021-11-26 14:56:30 +08:00
morris
16677b0d3c
global: make periph enable/disable APIs private
...
peripheral enable/disable usually should be managed by driver itself,
so make it as espressif private APIs, not recommended for user to use it
in application code.
However, if user want to re-write the driver or ports to other platform,
this is still possible by including the header in this way:
"esp_private/peripheral_ctrl.h"
2021-11-08 10:37:47 +08:00
Armando
c45c6f52f1
adc: support adc efuse-based calibration on esp32s3
2021-09-14 11:42:50 +08:00
Li Shuai
366d0a724a
light sleep: set wifi light sleep clock source to rtc slow clock
2021-08-04 21:31:47 +08:00
morris
1560d6f1ba
soc: add reset reasons in soc component
2021-07-13 10:45:38 +08:00
KonstantinKondrashov
aa1338bf23
wdt: Fix timeout and RTC_SLOW_CLK
...
RTC_SLOW_CLK
ESP32: 150kHz
ESP32-S2: 90kHz
ESP32-S3: 150kHz
ESP32-C3: 150kHz
2021-03-19 00:15:18 +08:00
Angus Gratton
d6f4d99d93
core system: Fix warnings in compilation when assertions are disabled
...
Adds a CI config for hello world that sets this, to catch future regressions
2021-03-03 10:26:57 +11:00
Chen Jian Xing
f71adec8fb
Support ESP32S3 (beta2) WiFi
2021-01-25 00:18:42 +08:00
KonstantinKondrashov
dada7cd035
global: Uses CCOUNT API instead of XTHAL macro
2021-01-12 16:24:23 +08:00
Renz Bagaporo
4cc6b5571b
esp_system: support riscv panic
2020-11-13 07:49:11 +11:00