Following the file renaming to use the "usb_dwc" prefix, this commit
updates the symbol names of those files to use the "usb_dwc" as well.
Some LL functions were also renamed so that the register name is
mentioned.
This commit updates the DWC_OTG based struct/ll/hal file names to
use the prefix "usb_dwc". This naming scheme reduces ambiguity if
another USB controller implementation is added.
As a result, "hcd.c" has been renamed to "hcd_dwc.c"
In previous gpio default isr, interrupt status bits get cleared at the exit of the isr.
However, for edge-triggered interrupt type, the interrupt status bit should be cleared before entering the per-pin handlers to avoid any potential interrupt lost.
Closes https://github.com/espressif/esp-idf/pull/6853
Wrap the ledc, i2c source files with the new caps in CMakeLists and linker.lf.
This could avoid potential source file not found warning during linking time.
essl_spi: fix wrong dummy cycle under quad spi mode ant add a test to verify spi quad mod
Closes IDF-5182 and IDF-5181
See merge request espressif/esp-idf!18680
This commit gives basic mmu driver framework. Now it is able to maintain
mmu virtual address usage on esp32, esp32s2 and esp32s3. Usage to
external virtual address should rely on mmu functions to know which
address range is available, instead of hardcoded.
This commit also improves psram memory that is added to the heap
allocator. Now it's added to the heap, according to the memory
alignment.
Closes https://github.com/espressif/esp-idf/issues/8295
sdio_slave: workaround the sdio_slave crash issue with release config + GCC11
Closes IDFCI-1296, IDFCI-1297, and IDFCI-1298
See merge request espressif/esp-idf!19680
This commit fixes gpio_hold_en(pin) function for ESP32, where after wakeup from deep sleep, the pin gets reset to default state and stop holding the pin level.
1.The dummy_bits is set to 4 in ESP32C3/C2, therefore, the data transmission started too early.This commit fix this issue by changing dummy_bits to 8.
2.Put the spi command the spi defintion in spi_types.h
3.Put the function which get spi command or dummy bits in spi_ll.h
Added a kconfig option. By default, when using ADC oneshot
driver, it will disable
DAC channels:
- ESP32: IO25, IO26
- ESP32S2: IO17, IO18
if ADC2 is in use.
You can disable this option, to measure DAC output, via internal ADC.
This is for test usage.
