- esp_supp_dpp_init : Ensures that the mode is set to station before
the API call.
- Ensures that dpp follows the path of init(esp_supp_dpp_init) ->
bootstrap(esp_supp_dpp_bootstrap_gen) -> listen(esp_supp_dpp_start_listen)
by returning errors if any of them is invoked out of order.
bugfix(nvs_flash) : fixed nvs_set functions behaviour when called sequentially with same key and different data type(s)
Closes IDFGH-9727
See merge request espressif/esp-idf!25581
Currently the component_requirements hint module does not work
as expected if the component list for a project is trimmed down.
With the new "all_component_info" dictionary info in project_description.json,
the module can produce hints even if cmake's COMPONENTS variable is
set.
Signed-off-by: Frantisek Hrbata <frantisek.hrbata@espressif.com>
Add new "all_component_info" dictionary into the
project_description.json file. It contains information about all
registered components presented in the __COMPONENT_TARGETS list.
Since components in this list are not fully evaluated, because only the first
stage of cmakefiles processing is done, it does not contain the same information
as the "build_component_info" dictionary. The "type", "file" and "sources" variables
are missing.
Most of the properties are already attached to the component target, so
this only adds INCLUDE_DIRS property to the target during the first cmakefiles
processing stage.
The "all_component_info" dict is generated in a separate function, even
though the original function for "build_component_info" could be
adjusted. This introduces a little bit of boilerplate, but keeps it
logically separated and probably easier if we want to extend it in the
future.
Signed-off-by: Frantisek Hrbata <frantisek.hrbata@espressif.com>
In esp_eth_phy_rtl8201.c:
Add 150ms delay after hardware reset, chage reset assertion time to 10ms
In esp_eth_phy_802_3.c:
Change reset function to use vTaskDelay for long (>=10ms) reset assertion time
Change esp_eth_phy_802_3_detect_phy_addr to check range 0-31 instead of 0-15.
For cases where the bootloader is not enabled with the security features
ends up receiving an incorrect application with flash encryption enabled
should not really program any security efuses.
In the startup sequence, we first used to program the ROM DL mode
configuration but now we check for the flash encryption related checks
first. If the flash encryption related checks finds that flash
encryption is not enabled on the device then it aborts the boot process.
This is the case with `CONFIG_SECURE_FLASH_CHECK_ENC_EN_IN_APP` enabled.
This would at-least ensure that accidental program of security enabled
application does not really program any ROM DL mode efuses and there is
chance to recover the device.
1. move startup_stack attr from soc_memory_type_desc_t to soc_memory_region_t and
remove unused aliased_iram field
2. all of the last level of RAM is retention dma accessible on esp32c3
3. remove esp32c2 and later chips retention dma accessible memory caps
4. allow allocate memory from RTC_RAM with MALLOC_CAP_EXEC cap
