support line mode 1-2-4-8 depend on targets.
fix sct mode dma descriptor counter compute issue.
add conf_bits_len setting API to control interval time.
fix(esp_phy): Allow "Enable USB when phy init" option only on supported targets
Closes IDFGH-10996 and IDFGH-11554
See merge request espressif/esp-idf!27364
- modify console example to use the new SOC_LIGHT_SLEEP_SUPPORTED
and SOC_DEEP_SLEEP_SUPPORTED macros when registering sleep commands
- remove exclusion of esp32p4 in basic and advanced example in
.build-test-rules.yml
- replace exclusion of esp32p4 for deep and light sleep tests with newly introduced macro
- remove the temporary disable check for esp32p4 and uses the
SOC_LIGHT_SLEEP_SUPPORTED maccro instead.
"Enable USB when phy init" Kconfig option would call esp_phy function
`phy_bbpll_en_usb()` that is not implemented for all targets.
Selecting this option for unsupported target results in linking error.
The necessity of this workaround is now defined soc_caps.h rather than
in the Kconfig.
Closes https://github.com/espressif/esp-idf/issues/12185
Increase LP_UART_EMPTY_THRESH_DEFAULT value to 4. The original value
could cause the FIFO become empty before filling next data into the FIFO
when the buadrate is high. TX_DONE interrupt would raise before actual
transmission complete in such case.
This header has been removed for the following reasons:
- Header is misplaced. 'xxx_types.h' headers should be placed in the 'hal'
component.
- The 'usb_xxx_endpoint_t' should be placed in the 'xxx_struct.h' header.
- Renamed usb_otg_periph.h/c to usb_dwc_periph.h/c to match naming convention
of other DWC OTG related files
- Added compatibility header for usb_otg_periph.h
usb_pins.h and usb_periph.h/c lists mappings of USB DWC signals to GPIOs used
to connect to external FSLS PHYs. However, those signals can be routed to any
GPIOs via the GPIO matrix. Thus, these mapping are meaningless and have been
deprecated.
This commit updates the "*_struct.h" files for the USB OTG peripheral:
- Added/removed some missing/non-existing register fields
- Added "reserved" place holders for registers that are missing due to IP
configuration.
- Added "usb_dwc_cfg.h" listing the USB OTG IP configuration for each target.
- Updated LL/HAL according to register field updates. Also tidied up the include
directives in those headers.
This commit adds a the SOC_HP_CPU_HAS_MULTIPLE_CORES convenience macro to
soc_caps.h. This is a convenience boolean cap to represent whether or not the
target has multiple cores, and is intended to be used when writing docs for
multiple targets.
This commit refactors SOC_USB_PERIPH_NUM as follows:
- Renamed to SOC_USB_OTG_PERIPH_NUM to avoid confusion with USB Serial JTAG
- Updated to unsigned integer "1U"
- Updated some build rules to depend on SOC_USB_OTG_SUPPORTED instead
Previously the DROM_HIGH_ADDR for esp32s3 was 0x3D000000, which
convers only 16 MB of address range. But esp32s3 supports 32 MB
external memory. So this address should be 0x3E000000
