Michael (XIAO Xufeng)
9b5d0f3322
spi: shown owner of spi host explicitly
2018-10-29 20:22:44 +08:00
Michael (XIAO Xufeng)
90d229eb6d
spi_master: speed up polling performance by putting into IRAM
2018-10-25 12:31:45 +08:00
michael
e5ed450d95
spi: move gpio direction config to common func for coinsistence
...
(MINOR CHANGE)
2018-10-04 14:57:31 +08:00
Michael (XIAO Xufeng)
2600f43822
spi_master: fix the command and address field when LSB_FIRST enabled
...
Resolves https://github.com/espressif/esp-idf/issues/2444 .
2018-10-04 14:57:30 +08:00
Michael (Xiao Xufeng)
4af51833f3
spi_master: add new polling mode to decrease time cost each transaction
2018-09-20 19:46:46 +08:00
Jeroen Domburg
4eb28b9ace
Merge branch 'feature/spi_burst_desc' into 'master'
...
spi_master: change to DMA burst mode when access descriptors
See merge request idf/esp-idf!2824
2018-08-21 16:54:38 +08:00
michael
404e99965d
spi_master: change high part config to allow transactions of 64 bytes
2018-08-16 18:55:09 +08:00
Michael (XIAO Xufeng)
203ceed1e7
spi_master: change to DMA burst mode when access descriptors
2018-08-08 13:56:01 +00:00
Angus Gratton
e5d2406b1d
Merge branch 'bugfix/spi_cs_setup_fulldup' into 'master'
...
fix(spi_master): allow to use cs_ena_pretrans in full duplex mode without…
See merge request idf/esp-idf!2576
2018-07-16 16:30:36 +08:00
Michael (XIAO Xufeng)
3d23fe9a61
feature(spi): provide macro to write multi-byte data straightly
...
resolves https://github.com/espressif/esp-idf/issues/2062
2018-07-02 15:34:47 +08:00
michael
8676830e61
fix(spi_master): allow to use cs_ena_pretrans in full duplex mode without command and address phases
2018-06-25 04:30:14 +00:00
Angus Gratton
73f6fb9fe7
Merge branch 'feature/spi_functions_in_iram' into 'master'
...
feature(spi_master): allow to place functions into IRAM to get higher efficiency
See merge request idf/esp-idf!2538
2018-06-19 07:25:12 +08:00
Michael (XIAO Xufeng)
9c23b8e596
feature(spi_master): allow to place functions into IRAM to get higher efficiency
2018-06-14 20:22:40 +08:00
Michael (XIAO Xufeng)
77077196fd
fix(spi): reset gpios that used by spi when deinited
2018-06-14 11:29:15 +08:00
Michael (XIAO Xufeng)
ebfda40b7c
refactor(spi): move pin information into soc folder
2018-06-14 11:29:15 +08:00
Michael (XIAO Xufeng)
939e5693a5
chore(spi): fix the terms of native to iomux
2018-06-06 06:08:39 +00:00
michael
5cf7d3768d
feat(spi_master): fine tune the timing of SPI
2018-06-06 06:08:39 +00:00
Michael (Xiao Xufeng)
45f8bcf3f8
fix(spi): allow using MISO on GPIO34-39
...
Breaking Changes: arguments of ``spicommon_bus_initialize_io`` are changed.
Closes https://github.com/espressif/esp-idf/issues/1736 .
2018-04-12 17:01:38 +08:00
Michael (Xiao Xufeng)
77629129c0
chore(spi): update the return value of spi init functions
2018-04-12 17:01:38 +08:00
Michael (Xiao Xufeng)
7563510758
feat(spi_master): allow output high speed data when dummy bits are not used.
2018-03-26 21:24:32 +08:00
Jonathan Kaufmann
a99d4d5a7f
Modified spi_bus_add_device so that it takes a constant *dev_config parameter.
...
Merges https://github.com/espressif/esp-idf/pull/1690
2018-03-19 12:17:45 +08:00
michael
f4be6ac84d
fix(spi_master): fix the logic in the ISR to prevent re-config registers when device is not changed.
2017-12-28 12:03:29 +08:00
michael
7a7b8fc182
refactor(spi_master): move the clock calculation from ISR to initialization.
2017-12-28 12:03:28 +08:00
michael
02573a8dc9
fix(spi_master): release temporary memory when queue new trans timeout.
2017-11-17 12:15:19 +08:00
michael
57e1d47ad7
fix(spi_master): fix the CS pin issue with GPIO 0.
...
Closes #909
2017-11-17 12:15:19 +08:00
michael
0330ec270a
feat(spi_master): add new feature allow use variable command and address field length for the same device.
...
Closes #654
2017-10-30 19:33:41 +08:00
Ivan Grokhotkov
e4616588b7
spi master: lock APB frequency while in transaction
2017-10-18 14:19:21 +08:00
Gabriel Carstoiu
8128bb95ef
fix(spi_slave): enable DMA clock when initialization.
...
merging in the code updates to the SPI master code done in commit b834fcf78a
.
TW#15670, Closes #1027
2017-10-17 12:20:40 +08:00
michael
074f36afff
fix(spi_master): fix the heap corruption bug that RX DMA writes over the temporary buffer boundary.
...
TW#15434
Closes #994 .
2017-09-19 16:47:14 +08:00
michael
b834fcf78a
fix(spi_master): this fix the SPI MOSI output missing bug.
2017-09-04 22:43:51 +08:00
Ivan Grokhotkov
3161854efb
Merge branch 'bugfix/spi_hd_rx' into 'master'
...
fix(spi_dma_rx): add check to avoid using SPI half-duplex mode DMA with both MOSI and MISO phases.
See merge request !1111
2017-08-28 17:36:58 +08:00
Ivan Grokhotkov
b636f81619
Merge branch 'bugfix/spi_command' into 'master'
...
fix(spi_master): fix the command field to make it more intuitive to use.
See merge request !1119
2017-08-28 10:29:56 +08:00
michael
0cb14f1648
fix(spi_dma_rx): add check to avoid using SPI half-duplex mode DMA with both MOSI and MISO phases.
2017-08-26 02:15:30 +08:00
michael
4c9754726f
fix(spi_master): fix the command field to make it more intuitive to use.
2017-08-21 20:37:57 +08:00
michael
a01db5569c
fix(spi_dma): fix the receive error with RX DMA start with non-aligned address.
2017-08-18 10:14:49 +08:00
Ivan Grokhotkov
159a2d01d1
Merge branch 'bugfix/spi_dma' into 'master'
...
bugfix(spi_master): fix several issues when using RX DMA
See merge request !1006
2017-08-16 18:55:25 +08:00
michael
ed1d084aea
fix(spi_master): make the address field more intuitive to use.
...
The address field should be placed at the highest bits of address and slv_wr_status registers. Instead of breaking the address into two parts and fill in each register, move the address to the highest bits and write to the registers respectively.
Breaking change: if you fill-in the SPI address filed in a previous version in some way and it works correctly, you still have to rewrite the address, in a more intuitive way.
2017-08-15 14:49:31 +08:00
michael
366e4397e9
fix(spi_dma_rx): fixed the invalid argument issue in full-duplex mode.
...
force rxlength=length and mosi=1 and inlink.start=1 on in full-duplex mode.
set rxlength > length is forbidden in full-duplex mode.
TW#12609, TW#14240, https://www.esp32.com/viewtopic.php?f=13&t=2519
2017-08-14 17:25:30 +08:00
michael
227b011f6a
fix(spi_master): fix SPI master, now able to transfer more than 32 bytes in non-DMA-accessable area.
...
apply for internal space to hold these data.
use DMA when it's enabled, no matter long or short.
TW#12226, github#551
2017-08-14 17:19:57 +08:00
Angus Gratton
8d7074ed5c
soc: Move esp_ptr_dma_capable() function to soc_memory_layout.h
2017-07-10 17:46:03 +08:00
Angus Gratton
71c70cb15c
heap: Refactor heap regions/capabilities out of FreeRTOS
...
Remove tagged heap API, rename caps_xxx to heap_caps_xxx
Also includes additional heap_caps_xxx inspection functions.
2017-07-10 17:46:03 +08:00
Jeroen Domburg
8af3fe4e84
Warn against and check for non-DMA-capable pointers being passed to SPI when DMA is used
2017-05-05 12:28:03 +08:00
devsaurus
530c3ca05c
components/driver/spi_master: free dma descriptors
...
Signed-off-by: Jeroen Domburg <jeroen@espressif.com>
2017-05-05 11:13:42 +08:00
Jeroen Domburg
bf0c32364a
SPI: Also check SPI_TRANS_USE_[T|R]XDATA when decifding to turn on MOSI/MISO. Fixes https://github.com/espressif/esp-idf/issues/488
2017-04-27 11:49:04 +08:00
Jeroen Domburg
881a90b8ab
SPI: SPI master clock calculation: n has a minimum of 2 to allow for both a low and a high cycle. Fixes https://github.com/espressif/esp-idf/issues/491
2017-04-27 11:49:04 +08:00
Jeroen Domburg
4c06dca15c
SPI: Small fixes according to MR comments
2017-04-27 11:49:04 +08:00
Jeroen Domburg
e9c372bc2d
SPI: Split common SPI stuff out of master driver; add slave driver; add workaround for DMA issue.
2017-04-27 11:49:04 +08:00
Angus Gratton
fd3ef4cdfe
Merge branch 'bugfix/github_fixes' into 'master'
...
Various fixes from Github
Some one-line fixes from Github PRs.
See merge request !689
2017-04-21 12:27:32 +08:00
Michael Kellner
eeb0aaa09e
spidriver: Display length errors correctly
...
SPI transfer length is bits, not bytes, so the error should indicate bits. Also, there are separate lengths for rx and
tx (confusingly named rxlength and length... if rxlength is 0, length is used). The code checks the tx length for the
rx, so it never validates rxlength.
Originally contributed as part of #511 https://github.com/espressif/esp-idf/pull/511
2017-04-21 11:03:07 +10:00
Michel Pollet
349a77cb55
components/driver: 'const' all config calls.
...
Some were, some weren't. They all could/should be.
Signed-off-by: Michel Pollet <buserror@gmail.com>
2017-04-13 18:33:33 +01:00