esp-idf/examples/peripherals/gpio/generic_gpio/README.md
pedro.minatel da471dfcd1 Examples README's updated on peripherals, system and wifi
Updated main examples README to add missing examples folders and Getting Started links
Updated wifi/fastscan example README
Updated wifi examples README
Updated wifi main examples README
Added instructions and removed obviousness from examples README
Updates on example README in peripherals, system and wifi
Updates on example README in peripherals and added wave form pictures on wave_gen example
Updates and review on example README
Revision on unit style convention
Added the getting started link for each supported version
Readme review and recommended enhancements
Added the default note on the wave form option info
Added the ESP32-C3 support information on the temperature sensor example README
Added Getting Started information for ESP32-S2 and ESP32-C3
Issue fixed on the supported target on README
Resolved merge conflict
2021-04-07 14:24:38 +00:00

2.6 KiB

Example: GPIO

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This test code shows how to configure GPIO and how to use it with interruption.

GPIO functions:

GPIO Direction Configuration
GPIO18 output
GPIO19 output
GPIO4 input pulled up, interrupt from rising edge and falling edge
GPIO5 input pulled up, interrupt from rising edge

Test:

  1. Connect GPIO18 with GPIO4
  2. Connect GPIO19 with GPIO5
  3. Generate pulses on GPIO18/19, that triggers interrupt on GPIO4/5

How to use example

Before project configuration and build, be sure to set the correct chip target using idf.py set-target <chip_name>.

Hardware Required

  • A development board with ESP32/ESP32-S2/ESP32-C3 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
  • A USB cable for Power supply and programming
  • Some jumper wires to connect GPIOs.

Configure the project

Build and Flash

Build the project and flash it to the board, then run the monitor tool to view the serial output:

Run idf.py -p PORT flash monitor to build, flash and monitor the project.

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for all the steps to configure and use the ESP-IDF to build projects.

Example Output

As you run the example, you will see the following log:

I (317) gpio: GPIO[18]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0 
I (327) gpio: GPIO[19]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0 
I (337) gpio: GPIO[4]| InputEn: 1| OutputEn: 0| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:1 
I (347) gpio: GPIO[5]| InputEn: 1| OutputEn: 0| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:1 
Minimum free heap size: 289892 bytes
cnt: 0
cnt: 1
cnt: 2
cnt: 3
cnt: 4
cnt: 5
cnt: 6
cnt: 7
cnt: 8
cnt: 9
cnt: 10
...

Troubleshooting

For any technical queries, please open an issue on GitHub. We will get back to you soon.