mirror of
https://github.com/espressif/esp-idf.git
synced 2024-10-05 20:47:46 -04:00
07471019ef
ADC can now be used from the ULP-RISCV on S2 after the RTC power parameters were
fixed in a624d8d061
Closes https://github.com/espressif/esp-idf/issues/11052
Closes https://github.com/espressif/esp-idf/issues/11040
33 lines
1.2 KiB
Markdown
33 lines
1.2 KiB
Markdown
| Supported Targets | ESP32-S2 | ESP32-S3 |
|
|
| ----------------- | -------- | -------- |
|
|
|
|
# ULP-RISC-V ADC Example
|
|
|
|
This example demonstrates how to use the ULP-RISC-V coprocessor to poll the ADC in deep sleep.
|
|
|
|
The ULP program periodically measures the input voltage on EXAMPLE_ADC_CHANNEL (by default ADC1 channel 0, GPIO1 on both ESP32-S2 and ESP32-S3). The voltage is compared to an upper threshold. If the voltage is higher than the threshold, the ULP wakes up the system.
|
|
|
|
By default, the threshold is set to 1.75V, approximately.
|
|
|
|
In this example, you need to connect a voltage source (e.g. a DC power supply) to the GPIO pin corresponding to the ADC channel specified in `ulp/example_config.h` (see the macros defined on the top of the header file). Feel free to modify the channel setting.
|
|
|
|
### Hardware Required
|
|
|
|
* A development board with a SOC which has a RISC-V ULP coprocessor (e.g., ESP32-S2 Saola)
|
|
* A USB cable for power supply and programming
|
|
|
|
## Example output
|
|
|
|
Below is the output from this example.
|
|
|
|
```
|
|
Not a ULP-RISC-V wakeup (cause = 0), initializing it!
|
|
Entering in deep sleep
|
|
|
|
ULP-RISC-V woke up the main CPU
|
|
Threshold: high = 2000
|
|
Value = 4095 was above threshold
|
|
Entering in deep sleep
|
|
```
|
|
|