mirror of
https://github.com/espressif/esp-idf.git
synced 2024-10-05 20:47:46 -04:00
31 lines
974 B
Markdown
31 lines
974 B
Markdown
# LEDC (LED PWM Controller) Example
|
|
|
|
This example shows how to control intensity of LEDs using ESP32's on-board hardware LED PWM Controller module.
|
|
|
|
## Functionality
|
|
|
|
Operations performed by example:
|
|
|
|
* Configuration of two timers (one high speed and the other low speed) that will be clocking four LEDC channels.
|
|
|
|
* Configuration of four channels of LEDC module, two channels will operate in high speed mode and two in low speed mode. Each channel will drive one GPIO / LED.
|
|
|
|
* Initialization of fade service to fade / gradually change intensity of LEDs.
|
|
|
|
* Operation of channels in a loop by cycling through four steps that will drive LEDs as follows:
|
|
|
|
1. Fade up / increase intensity
|
|
2. Fade down / decrease intensity (down to zero)
|
|
3. Set steady intensity
|
|
4. Set intensity to zero
|
|
|
|
## Hardware Setup
|
|
|
|
Connect four LEDs to the following LEDC channels / individual GPIOs:
|
|
|
|
* Channel 0 - GPIO18
|
|
* Channel 1 - GPIO19
|
|
* Channel 2 - GPIO4
|
|
* Channel 3 - GPIO5
|
|
|