alex/esp-idf
alex/esp-idf
1
0
Fork 0
mirror of https://github.com/espressif/esp-idf.git synced 2024-10-05 20:47:46 -04:00
Code Issues Actions 2 Packages Projects Releases Wiki Activity
8e140779e7
esp-idf/examples/peripherals/ledc/ledc_fade/README.md
Song Ruo Jing ad55230b0a ledc: Add support for esp32h2; Refactor ledc driver clock source selection related code 
LEDC examples and test cases are supported on ESP32H2.
   Switch to use general clock IDs for ledc_clk_cfg_t enum values.
   Deprecate LEDC_USE_RTC8M_CLK.
2023-01-30 19:19:34 +08:00

2.5 KiB
Raw Blame History

Supported Targets ESP32 ESP32-C2 ESP32-C3 ESP32-C6 ESP32-H2 ESP32-S2 ESP32-S3

LEDC Fade Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This example shows how to control intensity of LEDs using selected SoC's on-board hardware LED PWM Controller module.

How to use example

Hardware Required

  • A development board with any Espressif SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
  • A USB cable for power supply and programming

Connect four LEDs to the following LEDC channels / individual GPIOs:

Channel 0 Channel 1 Channel 2 Channel 3
ESP32 GPIO18 GPIO19 GPIO4 GPIO5
All other chips GPIO8 GPIO9 GPIO4 GPIO5

Configure the project

idf.py menuconfig

Build and Flash

Build the project and flash it to the board, then run the monitor tool to view the serial output:

Run idf.py -p PORT flash monitor to build, flash and monitor the project.

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

Running this example, you will see the four LEDs' brightness change repeatedly in the following orders

  • 1: Fade up / increase intensity on the LEDs connecting to Channel 0/1; Fade down / decrease intensity on the LEDs connecting to Channel 2/3
  • 2: Fade down / decrease intensity on the LEDs connecting to Channel 0/1;Fade up / increase intensity on the LEDs connecting to Channel 2/3
  • 3: All LEDs keep a stable intensity
  • 4: All LEDs are off

you can also see the following output log on the serial monitor:

1. LEDC fade up to duty = 4000
2. LEDC fade down to duty = 0
3. LEDC set duty = 4000 without fade
4. LEDC set duty = 0 without fade
...

Troubleshooting

  • Programming fail

    • Hardware connection is not correct: run idf.py -p PORT monitor, and reboot your board to see if there are any output logs.
    • The baud rate for downloading is too high: lower your baud rate in the menuconfig menu, and try again.

For any technical queries, please open an issue on GitHub. We will get back to you soon.