mirror of
https://github.com/espressif/esp-idf.git
synced 2024-10-05 20:47:46 -04:00
51 lines
2.0 KiB
Markdown
51 lines
2.0 KiB
Markdown
| Supported Targets | ESP32-H2 |
|
|
| ----------------- | -------- |
|
|
|
|
# Light Bulb Example
|
|
|
|
(See the `README.md` file in the upper level 'examples' directory for more information about examples.)
|
|
|
|
This test code shows how to configure Zigbee router device and use it as a light bulb
|
|
|
|
## Hardware Required
|
|
|
|
* One development board with ESP32-H2 SoC acting as Zigbee router (loaded with light bulb example)
|
|
* A USB cable for power supply and programming
|
|
* Choose another ESP32-H2 as Zigbee coordinator (see [light coordinator example](../light_coordinator))
|
|
* Choose another ESP32-H2 as Zigbee end-device (see [light switch example](../light_switch))
|
|
|
|
## Configure the project
|
|
|
|
Before project configuration and build, make sure to set the correct chip target using `idf.py set-target esp32h2`.
|
|
|
|
## Build and Flash
|
|
|
|
Build the project, flash it to the board, and start the monitor tool to view the serial output by running `idf.py -p PORT flash monitor`.
|
|
|
|
(To exit the serial monitor, type ``Ctrl-]``.)
|
|
|
|
## Example Output
|
|
|
|
As you run the example, you will see the following log:
|
|
|
|
light bulb:
|
|
I (9638) ESP_ZB_LIGHT: status: 255
|
|
I (9638) ESP_ZB_LIGHT: Zigbee stack initialized
|
|
I (9648) ESP_ZB_LIGHT: Start network steering
|
|
I (12368) ESP_ZB_LIGHT: Joined network successfully (Extended PAN ID: f9:54:2d:01:a0:03:f7:84, PAN ID: 0xf5b5)
|
|
I (12398) ESP_ZB_LIGHT: status: 0
|
|
I (18158) ESP_ZB_LIGHT: on/off attribute setting to 1
|
|
I (19388) ESP_ZB_LIGHT: on/off attribute setting to 0
|
|
I (20418) ESP_ZB_LIGHT: on/off attribute setting to 1
|
|
I (21558) ESP_ZB_LIGHT: on/off attribute setting to 0
|
|
I (22478) ESP_ZB_LIGHT: on/off attribute setting to 1
|
|
I (23088) ESP_ZB_LIGHT: on/off attribute setting to 0
|
|
|
|
## Light Control Functions
|
|
|
|
* By toggling the switch button (BOOT) on the ESP32-H2 board loaded with the `light switch` example, the LED on this board loaded with `light bulb` example will be on and off.
|
|
|
|
## Troubleshooting
|
|
|
|
For any technical queries, please open an [issue](https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.
|