mirror of
https://github.com/espressif/esp-idf.git
synced 2024-09-21 06:56:11 -04:00
67 lines
2.2 KiB
Markdown
67 lines
2.2 KiB
Markdown
| Supported Targets | ESP32-C6 | ESP32-H2 |
|
|
| ----------------- | -------- | -------- |
|
|
|
|
# OpenThread Radio Co-Processor (RCP) Example
|
|
|
|
This example demonstrates an [OpenThread Radio Co-Processor](https://openthread.io/platforms/co-processor).
|
|
|
|
OpenThread RCP doesn't function alone, it needs to work together with a Host and this example covers two common user scenarios:
|
|
- Work with a Host Processor to perform a [Thread Border Router](https://openthread.io/guides/border-router).
|
|
- Work as a [Thread Sniffer](https://openthread.io/guides/pyspinel/sniffer).
|
|
|
|
## How to use example
|
|
|
|
### Hardware Required
|
|
|
|
To run this example, a board with IEEE 802.15.4 module (for example ESP32-H2) is required.
|
|
|
|
### Configure the project
|
|
|
|
The default communication interface is port 0 of ESP32-H2 UART running at 460800 baud, change the configuration in [esp_ot_config.h](main/esp_ot_config.h) if you want to use another interface or need different communication parameters.
|
|
|
|
### RCP Size Optimization Configuration
|
|
|
|
To optimize the size of the RCP firmware, the following configurations are enabled by default:
|
|
|
|
```
|
|
CONFIG_COMPILER_OPTIMIZATION_SIZE=y
|
|
CONFIG_COMPILER_OPTIMIZATION_ASSERTIONS_SILENT=y
|
|
CONFIG_COMPILER_OPTIMIZATION_CHECKS_SILENT=y
|
|
CONFIG_COMPILER_SAVE_RESTORE_LIBCALLS=y
|
|
CONFIG_ESP_ERR_TO_NAME_LOOKUP=n
|
|
CONFIG_ESP_SYSTEM_PANIC_SILENT_REBOOT=y
|
|
CONFIG_LOG_DEFAULT_LEVEL_NONE=y
|
|
CONFIG_NEWLIB_NANO_FORMAT=y
|
|
CONFIG_OPENTHREAD_LOG_LEVEL_DYNAMIC=n
|
|
CONFIG_OPENTHREAD_LOG_LEVEL_NONE=y
|
|
```
|
|
Configure them via `idf.py menuconfig` if you need.
|
|
|
|
The firmware size are as follows (reference value):
|
|
|
|
```
|
|
Before Optimization After Optimization
|
|
|
|
esp_ot_rcp.bin for esp32h2 314KB 184KB
|
|
|
|
esp_ot_rcp.bin for esp32c6 299KB 208kb
|
|
```
|
|
|
|
### Build and Flash
|
|
|
|
Build the project and flash it to the board:
|
|
|
|
```
|
|
idf.py -p <PORT> build flash
|
|
```
|
|
|
|
Now you'll get an OpenThread RCP, you can try the following use cases:
|
|
|
|
#### Thread Border Router
|
|
|
|
Please refer to [ot_br](../ot_br) example for the setup steps.
|
|
|
|
#### Thread Sniffer
|
|
|
|
Please refer to [Thread Sniffer](https://openthread.io/guides/pyspinel/sniffer) for the detailed instructions.
|