mirror of https://github.com/espressif/esp-idf.git synced 2024-10-05 20:47:46 -04:00

History

Euripedes Rocha 4778d9b477 protocols/examples: Disable Wifi connection if not supported - Disable Kconfig option for Wifi if not supported by the SoC - Enable building mqtt examples when target is set to esp32h2		2023-05-30 13:26:45 +02:00
..
main	freertos: Remove legacy data types	2022-02-09 23:05:45 +08:00
CMakeLists.txt	tools: Increase the minimal supported CMake version to 3.16	2022-06-01 06:35:02 +00:00
pytet_socket_non_blocking.py	CI: Migrate socket example tests to pytest	2022-12-15 14:55:42 +08:00
README.md	protocols/examples: Disable Wifi connection if not supported	2023-05-30 13:26:45 +02:00
sdkconfig.ci	examples: Move non-block socket examples to a single app	2021-06-25 20:46:49 +08:00

README.md

Supported Targets	ESP32	ESP32-C2	ESP32-C3	ESP32-C6	ESP32-H2	ESP32-S2	ESP32-S3

TCP non-blocking client and server examples

(See the README.md file in the upper level 'examples' directory for more information about examples.)

The application aims to demonstrate a simple use of TCP sockets in a nonblocking mode. It could be configured to run either a TCP server, or a TCP client, or both, in the project configuration settings.

How to use example

The example is configured by default as the TCP client.

Note that the example uses string representation of IP addresses and ports and thus could be used on both IPv4 and IPv6 protocols.

TCP Client

In the client mode, the example connects to a configured hostname or address, sends the specified payload data and waits for a response, then closes the connection. By default, it connects to a public http server and performs a simple http GET request.

TCP Server

The server example creates a non-blocking TCP socket with the specified port number and polls till a connection request from the client arrives. After accepting a request from the client, a connection between server and client is established, and the application polls for some data to be received from the client. Received data are printed as ASCII text and retransmitted back to the client.

The server could listen on the specified interface (by the configured bound address) and serves multiple clients. It resumes to listening for new connections when the client's socket gets closed.

Hardware Required

This example can be run on any commonly available ESP32 development board.

Configure the project

idf.py menuconfig

Set following parameters under Example Configuration Options:

Set EXAMPLE_TCP_SERVER to use the example as a non-blocking TCP server
- Configure EXAMPLE_TCP_SERVER_BIND_ADDRESS to a string representation of the address to bind the server socket to.
- Configure EXAMPLE_TCP_SERVER_BIND_PORT to the port number.
Set EXAMPLE_TCP_CLIENT to use the example as a non-blocking TCP client
- Configure EXAMPLE_TCP_CLIENT_CONNECT_ADDRESS to a string representation of the address to connect the client to.
- Configure EXAMPLE_TCP_CLIENT_CONNECT_PORT to the port number.
Configure Wi-Fi or Ethernet under "Example Connection Configuration" menu. See "Establishing Wi-Fi or Ethernet Connection" section in examples/protocols/README.md for more details.

Build and Flash

Build the project and flash it to the board, then run monitor tool to view serial output:

idf.py -p PORT flash monitor

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Troubleshooting

Follow the same troubleshooting instruction as for the standard TCP sever and the TCP client, using the host tools and scripts as descibed in the upper level documentation on BSD socket examples.