esp-idf/examples/protocols/sockets/tcp_client/README.md

73 lines
2.5 KiB
Markdown

# TCP Client example
(See the README.md file in the upper level 'examples' directory for more information about examples.)
The application creates a TCP socket and tries to connect to the server with predefined IP address and port number. When a connection is successfully established, the application sends message and waits for the answer. After the server's reply, application prints received reply as ASCII text, waits for 2 seconds and sends another message.
## How to use example
In order to create TCP server that communicates with TCP Client example, choose one of the following options.
There are many host-side tools which can be used to interact with the UDP/TCP server/client.
One command line tool is [netcat](http://netcat.sourceforge.net) which can send and receive many kinds of packets.
Note: please replace `192.168.0.167 3333` with desired IPV4/IPV6 address (displayed in monitor console) and port number in the following command.
In addition to those tools, simple Python scripts can be found under sockets/scripts directory. Every script is designed to interact with one of the examples.
### TCP server using netcat
```
nc -l 192.168.0.167 -p 3333
```
### Python scripts
Script tcpserver.py contains configuration for port number and IP version (IPv4 or IPv6) that has to be altered to match the values used by the application. Example:
```
IP_VERSION = 'IPv4'
PORT = 3333;
```
## Hardware Required
This example can be run on any commonly available ESP32 development board.
## Configure the project
```
make menuconfig
```
Set following parameter under Serial Flasher Options:
* Set `Default serial port`.
Set following parameters under Example Configuration Options:
* Set `IP version` of example to be IPV4 or IPV6.
* Set `IPV4 Address` in case your chose IP version IPV4 above.
* Set `IPV6 Address` in case your chose IP version IPV6 above.
* Set `Port` number that represents remote port the example will connect to.
Configure Wi-Fi or Ethernet under "Example Connection Configuration" menu. See "Establishing Wi-Fi or Ethernet Connection" section in [examples/protocols/README.md](../../README.md) for more details.
## Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
```
make -j4 flash monitor
```
(To exit the serial monitor, type ``Ctrl-]``.)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
## Troubleshooting
Start server first, to receive data sent from the client (application).