mirror of
https://github.com/espressif/esp-idf.git
synced 2024-10-05 20:47:46 -04:00
61 lines
1.5 KiB
Markdown
61 lines
1.5 KiB
Markdown
| Supported Targets | ESP32-S2 | ESP32-S3 |
|
|
| ----------------- | -------- | -------- |
|
|
|
|
# USB Mass Storage Class example
|
|
|
|
## Overview
|
|
|
|
This example demonstrates usage of Mass Storage Class to get access to storage on USB memory stick.
|
|
Example caries out read and write file operations, as USB storage is mounted to Virtual filesystem.
|
|
|
|
### Hardware Required
|
|
|
|
* Development board with USB capable ESP SoC (ESP32-S2/ESP32-S3)
|
|
* A USB cable for Power supply and programming
|
|
* A USB memory stick
|
|
|
|
### Common Pin Assignments
|
|
|
|
If your board doesn't have a USB A connector connected to the dedicated GPIOs,
|
|
you may have to DIY a cable and connect **D+** and **D-** to the pins listed below.
|
|
|
|
```
|
|
ESP BOARD USB CONNECTOR (type A)
|
|
--
|
|
| || VCC
|
|
[GPIO19] ------> | || D-
|
|
[GPIO20] ------> | || D+
|
|
| || GND
|
|
--
|
|
```
|
|
|
|
### Build and Flash
|
|
|
|
Build the project and flash it to the board, then run monitor tool to view serial output:
|
|
|
|
```
|
|
idf.py -p PORT flash monitor
|
|
```
|
|
|
|
(To exit the serial monitor, type ``Ctrl-]``.)
|
|
|
|
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
|
|
|
|
## Example Output
|
|
|
|
```
|
|
...
|
|
I (274) cpu_start: Starting scheduler on PRO CPU.
|
|
I (339) APP: Waiting for USB stick to be connected
|
|
Device info:
|
|
PID: 0x5678
|
|
VID: 0xFFFF
|
|
iProduct: Disk 2.0
|
|
iManufacturer: USB
|
|
iSerialNumber: 92072836B2589224378
|
|
I (719) APP: Writing file
|
|
I (749) APP: Reading file
|
|
I (749) APP: Read from file: 'Hello World!'
|
|
I (759) APP: Done
|
|
```
|