According to the ESP32-S2/S3 TRM, the output pin's mode is set in the RTC_GPIO_PINn_REG
by programming the RTC_GPIO_PINn_PAD_DRIVER bit. The current ULP RISC-V RTCIO driver
however, incorrectly programs the RTC_IO_TOUCH_PADn_REG register field RTC_IO_TOUCH_PADn_DRV.
This commit fixes the bug.
This commit fixes an issue where in the ULP RISC-V I2C example causes
a spurious wakeup of the main CPU because of a Trap signal when the ULP
core does not meet the wakeup threshold values. This was due to the fact
that the RTC_CNTL_COCPU_DONE signal was being set before the
RTC_CNTL_COCPU_SHUT_RESET_EN signal which was causing the the ULP RISC-V
core to not reset properly on each cycle.
Closes https://github.com/espressif/esp-idf/issues/10301
the variable "IDF_TARGET" is only used under a if clause
"if(ULP_C0CPU_IS_RISCV)". while building a non-riscv target,
there will be a cmake warning:
CMake Warning:
Manually-specified variables were not used by the project:
IDF_TARGET
Due to poor accuracy the ESP32 ULP TSENS instructions is not recommend for use.
We keep the instruction itself to support users which are already using it,
but should remove it from examples and docs to avoid encouring any new usage of it.
This updates the minimal supported version of CMake to 3.16, which in turn enables us to use more CMake features and have a cleaner build system.
This is the version that provides most new features and also the one we use in our latest docker image for CI.
RTC_CNTL_COCPU_SHUT_RESET_EN register was being reset during ULP RISC-V
initialization which does not let the ULP RISC-V coprocessor to reset
after it goes to halt. For proper operation of the coprocessor, it must
be reset after each cycle and hence this commit keeps
RTC_CNTL_COCPU_SHUT_RESET_EN set.
Moved the following kconfig options out of the target component:
* CONFIG_ESP*_DEFAULT_CPU_FREQ* -> esp_system
* ESP*_REV_MIN -> esp_hw_support
* ESP*_TIME_SYSCALL -> newlib
* ESP*_RTC_* -> esp_hw_support
Where applicable these target specific konfig names were merged into
a single common config, e.g;
CONFIG_ESP*_DEFAULT_CPU_FREQ -> CONFIG_ESP_DEFAULT_CPU_FREQ_MHZ
Due to a hardware issue ULP support on S3 is temporarily disabled until a fixed is released.
Running ULP + sleep together can potentially cause permanent damage to the chip.
This commit enables ULP FSM support for esp32s3 and updates ULP FSM code
flow for other chips.
It adds C Macro support for the ULP FSM instruction set on esp32s2 and
esp32s3.
The unit tests are also updated to test ULP FSM on ep32s2 and esp32s3.
This commit refactors the ulp component.
Files are now divided based on type of ulp, viz., fsm or risc-v.
Files common to both are maintained in the ulp_common folder.
This commit also adds menuconfig options for ULP within the ulp
component instead of presenting target specific configuations for ulp.
