1. add check in the gdma driver, to prevent multiple channels connecting
to the same peripheral
2. memory copy DMA ID will occupy the peripheral's DMA ID on some ESP
targets (e.g. esp32c3/s3). We should search for a free one when
install async memcpy driver.
Closes https://github.com/espressif/esp-idf/issues/10575
As heap block may be allocated into multiple non-continuous chunks, to
reserve enough memory for dma/internal usage, we do the malloc in the
step of max available block.
introduced in e44ead5356
1. The int8M power domain config by default is PD. While LEDC is using
RTC8M as clock source, this power domain will be kept on.
But when 8MD256 is used as RTC clock source, the power domain should
also be kept on.
On ESP32, there was protection for it, but broken by commit
e44ead5356. Currently the power domain
will be forced on when LEDC is using RTC8M as clock source &&
!int8m_pd_en (user enable ESP_PDP_DOMAIN_RTC8M in lightsleep). Otherwise
the power domain will be powered off, regardless of RTC clock source.
In other words, int8M domain will be forced off (even when 8MD256
used as RTC clock source) if LEDC not using RTC8M as clock source, user
doesn't enable ESP_PDP_DOMAIN_RTC8M, or in deep sleep.
On later chips, there's no such protection, so 8MD256 could't be used as
RTC clock source in sleep modes.
This commit adds protection of 8MD256 clock to other chips. Fixes the
incorrect protection logic overriding on ESP32. Now the power domain
will be determiend by the logic below (order by priority):
1. When RTC clock source uses 8MD256, power up
2. When LEDC uses RTC8M clock source, power up
3. In deepsleep, power down
4. Otherwise determined by user config of ESP_PDP_DOMAIN_RTC8M,
power down by default. (This is preferred to have highest
priority, but it's kept as is because of current code structure.)
2. Before, after the macro `RTC_SLEEP_CONFIG_DEFAULT` decides dbias, the
protection above may force the int8m PU. This may cause the inconsistent
of dbias and the int8m PU status.
This commit lifts the logic of pd int8m/xtal fpu logic to upper layer
(sleep_modes.c).
Related: https://github.com/espressif/esp-idf/issues/8007, https://github.com/espressif/esp-idf/pull/8089
temp
ADC calibration scheme and algorithm are not changed. Only the eFuse bit BLOCK1_VERSION is changed. This MR updated the logic to recognize the adc efuse version
For some of the MSPI high frequency setting (e.g. 80M DDR mode Flash or PSRAM), timing tuning is required.
Certain delays will be added to the MSPI RX direction. When system clock switches down, the delays should be
cleared. When system clock switches up, the delays should be restored.
External memory is accessed via SPI0. When modifying the SPI0 registers,
should put the code in internal RAM. Otherwise when there is an ongoing
SPI0 transaction, CPU changes the SPI0 registers. This is dangerous.
Besides, modifying SPI0 registers may lead external memory to an
unstable state. Therefore putting these code in internal RAM is
necessary.
When doing OCode self-calibration in rtc_init.c, it will change the
system clock from PLL to XTAL, which is in a lower frequency, and MSPI
timing tuning is not needed. Therefore we should modify the timing
configurations accordingly, and set it back after the calibration.
This is a temporary fix
