define: lock_bits = (lock->status & LOCK_MASK) >> LOCK_SHIFT; This `lock_bits` is the Bit 29-20 of the lock->status
1. spi_hdl_1:
acquire_end_core():
uint32_t status = lock_status_clear(lock, dev_handle->mask & LOCK_MASK);
Becuase this is the first `spi_hdl_1`, so after this , lock_bits == 0`b0. status == 0
2. spi_hdl_2:
acquire_core:
uint32_t status = lock_status_fetch_set(lock, dev_handle->mask & LOCK_MASK);
Then here status is 0`b0, but lock_bits == 0`b10. Because this is the `spi_hdl_2`
3. spi_hdl_2:
`acquire_core` return true, because status == 0. `spi_bus_lock_acquire_start(spi_hdl_2)` then won't block.
4. spi_hdl_2:
spi_device_polling_end(spi_hdl_2).
5. spi_hdl_1:
acquire_end_core:
status is 0, so it cleas the lock->acquiring_dev
6. spi_hdl_2:
spi_device_polling_end:
assert(handle == get_acquiring_dev(host)); Fail
Closes https://github.com/espressif/esp-idf/issues/8179
In previous gpio default isr, interrupt status bits get cleared at the exit of the isr.
However, for edge-triggered interrupt type, the interrupt status bit should be cleared before entering the per-pin handlers to avoid any potential interrupt lost.
Closes https://github.com/espressif/esp-idf/pull/6853
Wrap the ledc, i2c source files with the new caps in CMakeLists and linker.lf.
This could avoid potential source file not found warning during linking time.
essl_spi: fix wrong dummy cycle under quad spi mode ant add a test to verify spi quad mod
Closes IDF-5182 and IDF-5181
See merge request espressif/esp-idf!18680
uart: update console docs about frequency for ESP32-C2, move frequency of clock sources out of HAL
Closes IDF-5424 and IDF-4332
See merge request espressif/esp-idf!19274
ledc_ls_timer_update is required only when CLK_DIV and DUTY_RES bits are changed.
Calling ledc_timer_rst while re-configure PWM frequency through ledc_set_freq can cause glitch in the signal
Internally, disable usb serial jtag DP pin's pullup when calling gpio_ll_pullup_dis and rtcio_ll_pullup_disable
At usb serial jtag setup/install, re-enable DP pin's pullup
Closes https://github.com/espressif/esp-idf/issues/9495
Add a check in spi_master driver to prevent using both 'trans->length'
and 'trans->rxlength' on chips other than ESP32 and ESP32S2 which hardware
not support using both TX and RX phases in half-duplex mode
There are two ways to know which transaction descriptor is finished,
by either calling `spi_device_get_trans_result`, or getting it from `post_cb`.
When `SPI_DEVICE_NO_RETURN_RESULT` is set, driver will not push finished
transaction descriptors into the queue. So you can't get it from
`spi_device_get_trans_result`. The only way to know this is via `post_cb`.
update document for function `spi_bus_add_device`
