Omar Chebib
9faeca3d1c
I2C: Fix SCL period timings on ESP targets
...
The output frequency is now more accurate as the SCL period timings have been fixed.
This fix applies for ESP32, ESP32S3, ESP32C3 and ESP32H2
2022-08-18 02:45:36 +00:00
morris
a1c4397ce2
Merge branch 'bugfix/cpu_cycle_count_not_iram_v4.3' into 'release/v4.3'
...
HAL: place cpu_ll_get_cycle_count in IRAM (v4.3)
See merge request espressif/esp-idf!18294
2022-06-22 11:42:27 +08:00
Marius Vikhammer
537f802260
HAL: place cpu_ll_get_cycle_count in IRAM
...
Closes https://github.com/espressif/esp-idf/issues/9008
2022-05-28 14:31:33 +08:00
jingli
8309e3e5ce
esp_hw_support/sleep: fix cannot lightsleep again after a wakeup from ULP
...
Since ulp wakeup signal are connected to ulp int raw(except esp32), we
need to clear ulp int raw before sleep when ulp wakeup enabled. Otherwise,
if the ulp int raw is already set, chip will not sleep properly.
Closes https://github.com/espressif/esp-idf/issues/6229
2022-05-19 23:54:29 +08:00
Marius Vikhammer
cd598bd7c0
Merge branch 'bugfix/inline_intrmask_from_isr_v4.3' into 'release/v4.3'
...
freertos: always inline xPortSetInterruptMaskFromISR and vPortClearInterruptMaskFromISR (v4.3)
See merge request espressif/esp-idf!17326
2022-03-16 13:45:32 +08:00
Marius Vikhammer
491b95925e
spi flash: fix cache accessed while disabled issues at -O0
...
mask_get_id and gpio_hal_iomux_func_sel were called while cache
is disabled, but were not inlined as expected at -0O.
Force these functions to always be inlined.
2022-03-11 09:39:50 +08:00
Ondrej Kosta
8f1f424390
esp_eth: EMAC start/stop optimization
2022-03-07 14:54:55 +01:00
Ondrej Kosta
3c8bab0285
Fixed ESP32 EMAC driver insufficient TX buffer size
which could followed esp_eth_stop and esp_eth_start sequence
2022-03-07 14:54:33 +01:00
Sergey Gorban
3f49170ab1
Fixed error in "touch_ll_get_sleep_time" function for ESP32
...
Merges https://github.com/espressif/esp-idf/pull/6895
2022-02-28 09:45:43 +00:00
Gustavo Henrique Nihei
6fb126657a
spi: Fix SPI Slave TX/RX bitlen configuring wrong registers
...
The maximum input length for the SPI Slave should be applied to the read
buffer configuration, not for the write buffer. Similarly, the output
configuration should also target the write buffer.
2021-11-25 12:03:54 +08:00
Jiang Jiang Jian
b1290591df
Merge branch 'bugfix/register_non_32bit_access_v4.3' into 'release/v4.3'
...
hal: avoid non-32bit access to registers (v4.3)
See merge request espressif/esp-idf!15616
2021-11-23 07:09:41 +00:00
Marius Vikhammer
79b59947d8
aes: fix potential unaligned access of buffers
...
https://github.com/espressif/esp-idf/issues/7236
2021-11-04 10:35:55 +08:00
morris
62bd98158f
hal: avoid non-32bit access to registers
2021-10-25 11:33:50 +08:00
SalimTerryLi
29accf2533
soc/ll: workaround compiler bug that generate 8/16 bits inst instead of 32 bits one
...
Note: on ESP32 UART rxfifo seems to be read as u8 instead of u32 to make it work
2021-10-12 10:42:04 +08:00
SalimTerryLi
f23acef8eb
MCPWM/deadtime: fix and sync preset deadtime modes with well-known definition
...
Closes https://github.com/espressif/esp-idf/issues/7321
2021-08-03 14:27:34 +08:00
Cao Sen Miao
9c7d2c7595
spi_flash: fix cs line setup to make the flash driver more stable
2021-06-15 15:27:51 +08:00
Michael (XIAO Xufeng)
9da031e0c3
Merge branch 'bugfix/twai_caps_naming_and_tidy_up_v4.3' into 'release/v4.3'
...
Fix TWAI caps (backport v4.3)
See merge request espressif/esp-idf!13304
2021-04-28 17:47:35 +00:00
Darian Leung
07291fdd27
TWAI: FIFO overrun handling and errata workarounds
...
This commit adds handling for FIFO overruns and
adds workarounds for HW errats on the ESP32.
Closes https://github.com/espressif/esp-idf/issues/2519
Closes https://github.com/espressif/esp-idf/issues/4276
2021-04-26 19:35:13 +08:00
Darian Leung
b8e31efcac
TWAI: Fix incorrect CAP name
...
Fixes a bug where SOC_TWAI_BRP_DIV_SUPPORTED was mistyped preventing
slower bit rates from being enabled on ESP32 revision 2 and 3 chips
2021-04-26 19:34:30 +08:00
Omar Chebib
84dc42c4b0
gpio: Disable USB JTAG when setting pins 18 and 19 as GPIOs on ESP32C3
...
When `DIS_USB_JTAG` eFuse is NOT burned (`False`), it is not possible
to set pins 18 and 19 as GPIOs. This commit solves this by manually
disabling USB JTAG when using pins 18 or 19.
The functions shall use `gpio_hal_iomux_func_sel` instead of
`PIN_FUNC_SELELECT`.
2021-04-12 17:45:06 +08:00
aleks
d761226f36
driver: fix uart handler in iram calls inline uart_ll_is_tx_idle
2021-04-01 09:56:56 +02:00
Michael (XIAO Xufeng)
b75a5fd03a
Merge branch 'bugfix/adc_power_issue_4.3' into 'release/v4.3'
...
adc: fix adc power issue (v4.3)
See merge request espressif/esp-idf!12921
2021-03-30 17:15:09 +00:00
Armando
f48346f22f
adc: apply adc power API to adc driver
2021-03-26 17:41:20 +08:00
fuzhibo
918875424e
fix: clear interrupt in touch sensor initialization
2021-03-16 11:37:41 +08:00
Armando
66d10f0eec
spi: refactor spi_common dma allocator
2021-02-25 11:01:33 +08:00
Armando
ffc4ff5a8c
spi: apply gdma allocator to SPI
2021-02-25 11:01:16 +08:00
Michael (XIAO Xufeng)
da4b4fc565
Merge branch 'bugfix/mcpwm_can_set_two_falut_signal' into 'master'
...
mcpwm: fix second fault line broken issue
Closes IDFGH-4194
See merge request espressif/esp-idf!12119
2021-01-27 11:36:30 +08:00
Michael (XIAO Xufeng)
3d7da2c8ff
adc: simplify LL on C3
2021-01-25 15:08:55 +08:00
morris
ceab7daea8
mcpwm: fix wrong capture edge
2021-01-22 16:17:59 +08:00
Li Shuai
a43de3a44b
fix set UART_FORCE_XOFF
can't stop new Tx request issue
2021-01-19 14:51:22 +08:00
Li Shuai
355dd10257
light sleep: dfs support for esp32c3
2021-01-19 14:50:58 +08:00
ninh
659d805411
esp_wifi: light sleep optimization
2021-01-18 15:31:03 +08:00
ninh
27aa6c289f
components/pm: Add slp gpio configure workaround
2021-01-15 15:34:45 +08:00
Renz Bagaporo
ff2d9fd96c
[freertos] Silence sign-conversion warning
2021-01-14 10:54:15 +11:00
Angus Gratton
f683db7aea
Merge branch 'feature/c3_IDF-2554' into 'master'
...
global: Uses CCOUNT API instead of XTHAL macro
Closes IDF-2554
See merge request espressif/esp-idf!11954
2021-01-13 12:55:21 +08:00
KonstantinKondrashov
dada7cd035
global: Uses CCOUNT API instead of XTHAL macro
2021-01-12 16:24:23 +08:00
morris
753a929525
global: fix sign-compare warnings
2021-01-12 14:05:08 +08:00
morris
9e7d2c0065
esp32c3: format and clean up interrupt and os port code
2021-01-05 15:39:46 +08:00
Felipe Neves
5d316ac142
interrupt: added INTC FLEXIBLE capabillity to esp32c3 CPU caps
2021-01-05 15:39:46 +08:00
Felipe Neves
09bc1580be
intr_allocator: add abstractions for priority, type and edge-ack interrupt controller functions
2021-01-05 15:39:46 +08:00
Angus Gratton
f09b8ae7a4
driver: Add esp32c3 ADC driver
...
Based on internal commit 3ef01301fffa552d4be6d81bc9d199c223224305
2020-12-23 09:53:24 +11:00
Angus Gratton
27a9cf861e
driver: Add esp32c3 drivers (except ADC/DAC) and update tests
...
Some ESP32-C3 drivers are still pending.
Based on internal commit 3ef01301fffa552d4be6d81bc9d199c223224305
2020-12-23 09:53:24 +11:00
Marius Vikhammer
457ce080ae
AES: refactor and add HAL layer
...
Refactor the AES driver and add HAL, LL and caps.
Add better support for running AES-GCM fully in hardware.
2020-12-10 09:04:47 +00:00
Angus Gratton
7c08be5771
hal: Add initial ESP32-C3 support
...
From internal commit 7761d6e8
2020-11-30 15:23:15 +11:00
Armando
05a4a8d864
uart: seperate sclk and baudrate setting
2020-11-24 19:12:52 +08:00
Armando
fb8b905539
uart: add uart support on esp32s3
2020-11-24 19:12:51 +08:00
Michael (XIAO Xufeng)
af992c26bc
Merge branch 'bugfix/fix_x32k_startup_slow_bug' into 'master'
...
bugfix: Fix xtal 32k not oscillate or oscillate too slowly issue for esp32
See merge request espressif/esp-idf!10519
2020-11-24 17:37:29 +08:00
chaijie
a48b5246cc
ESP32: Fix xtal 32k not oscillate or oscillate too slowly issue
...
ESP32 in revision0 and revision1 uses touchpad to provide
current to oscillate xtal 32k. But revision2 and revision3
do not need to do that.
Note: touchpad can not work and toupad/ULP wakeup sources
are not available when toupad provides current to xtal 32k
2020-11-23 19:38:11 +08:00
Armando
9c507982aa
spi: fix spi_ll.h func name
...
On esp32 and esp32s2:
``spi_ll_dma_set_out_eof_generation`` is modified to
``spi_ll_dma_set_rx_eof_generation``.
``spi_dma_ll_set_rx_eof_generation`` is modified to
``spi_dma_ll_set_out_eof_generation``.
Because on ESP32S3, this bit ``out_eof_mode`` is moved to DMA related
registers.
2020-11-19 19:33:02 +08:00
Michael (XIAO Xufeng)
caf83b88ba
Merge branch 'feature/bringup_i2c_for_s3' into 'master'
...
I2C: Add support for esp32s3 and add source clock allocator
Closes IDF-2011
See merge request espressif/esp-idf!10923
2020-11-12 22:12:58 +08:00