* add support for KSZ8001, KSZ8021, KSZ8031, KSZ8051 and KSZ8061
* remove duplicate code
* simplify architecture to make the code base extensible (for future work)
peripheral enable/disable usually should be managed by driver itself,
so make it as espressif private APIs, not recommended for user to use it
in application code.
However, if user want to re-write the driver or ports to other platform,
this is still possible by including the header in this way:
"esp_private/peripheral_ctrl.h"
Increase reset assertion time from 100µs (as specified minimum in the datasheet) to 150µs.
Some specimen of the LAN8720 need the reset signal asserted longer than 100µs to initialise properly. Otherwise they are in a zombie state where they are establishing and loosing an Ethernet link once in a seconds interval.
* Disable Tx interrupts to fix race condition of missing Rx interrupt
* Check if GPIO interrupt is asserted periodically if the ISR event missed
Closes https://github.com/espressif/esp-idf/issues/6414
Ethernet driver events properly bounded with ESP NETIF actions to support multiple Ethernet modules used at a time.
Components using Ethernet updated to conform with new API.
Closes https://github.com/espressif/esp-idf/issues/7318
Increase the interrupt reassert level timing so the chances of missing
two consecutive events are minimal.
Enable only SIR_RECV interrupt event, so the SEND events are not used
for GPIO signal.
If the GPIO interrupt is re-asserted too quickly it could be missed. If this happens the driver goes silent and never receives any data. Recover by periodic checks of the IO signal level
Also updated KSZ8851SNL per internal code review:
* Removed Link status change interrupt as it's handled with polling
* Added auto negotiation timeout
* Updated typedefs, moved types to appropriate source, updated
components/esp_eth/src/ksz8851.h to use only inherent device types
* Applied IDF code formatting
* Updated header file order to include first the most generic to more
specific
The issue typically happens for link-down during Tx. Added two retry levels, one before checking the sanity of the w5500 phy register and another for the Tx done itself (if the device is in the sane state)
Closes https://github.com/espressif/esp-idf/issues/6233
Reading SPI data may come in 4-byte units and thus result in unwanted
overwrites if smaller size registers read, especially if multiple placed
one after another. Fixed by using direct reads to `trans` structure for
sizes smaller or equal to 4.
Closes https://github.com/espressif/esp-idf/issues/6579
