esp-idf-ssd1306

SSD1306/SH1106 driver for esp-idf

I used this repository as a reference.
I used this font file.

Software requirements

esp-idf v4.4 or later.
This is because this version supports ESP32-C3.

Installation

git clone https://github.com/nopnop2002/esp-idf-ssd1306
cd esp-idf-ssd1306/TextDemo/
idf.py set-target {esp32/esp32s2/esp32s3/esp32c3}
idf.py menuconfig
idf.py flash

Note
For some reason, there are development boards that cannot use GPIO06, GPIO08, GPIO09, GPIO19 for SPI clock pins.
According to the ESP32C3 specifications, these pins can also be used as SPI clocks.
I used a raw ESP-C3-13 to verify that these pins could be used as SPI clocks.

Configuration

You have to set this config value with menuconfig.

CONFIG_INTERFACE
CONFIG_PANEL
CONFIG_OFFSETX
CONFIG_FLIP
CONFIG_SDA_GPIO
CONFIG_SCL_GPIO
CONFIG_RESET_GPIO
CONFIG_MOSI_GPIO
CONFIG_SCLK_GPIO
CONFIG_CS_GPIO
CONFIG_DC_GPIO

Generic SSD1306 128x32 i2c

Generic SSD1306 128x64 i2c

Generic SH1106 128x64 i2c

Hardware scroll Not support
Left:1.3 inch SH1106
Right:0.96 inch SSD1306

128x64 TTGO

Unlike other ESP32 development boards, the RTC_CLOCK crystal on this board uses a 26MHz one.
You need to change the RTC CLOCK frequency to 26MHz using menuconfig.