esp-idf-ssd1306/MeterDemo/README.md

MeterDemo for SSD1306

I borrowed the BIT MAP data from here.

Wire cables should be as short as possible.

I used a 10 cm wire cable.
However, it is sometimes affected by noise.

Convert from BITMAP data to Page and Segment

This sample shows how to quickly redraw a BITMAP image.
High-speed drawing is possible by converting BITMAP data to Page and Segment.
You can use ssd1306_bitmaps function as converter.

Analog source

You will need an analog source to run this demo.
Connect the analog source to the following GPIO.
These are all channel 0 of ADC1.

• Analog input gpio for ESP32 is GPIO36. 12Bits width.
• Analog input gpio for ESP32S2 is GPIO01. 13Bits width.
• Analog input gpio for ESP32S3 is GPIO01. 12Bits width.
• Analog input gpio for ESP32C2 is GPIO00. 12Bits width.
• Analog input gpio for ESP32C3 is GPIO00. 12Bits width.
• Analog input gpio for ESP32C6 is GPIO00. 12Bits width.

Schematic I used:

ESP32 3V3 ----------- CDS ---+---+
                             |   |
ESP32 Analog input ----------+   |
                                 |
ESP32 GND ------ Register -------+