GY-63_MS5611/libraries/PCF8574/examples/buttonRead8/buttonRead8.ino

/**
 *  @file
 *  @Author Septillion (https://github.com/sseptillion)
 *  @date 2016-05-20
 *  @brief Example how to use buttonRead8()
 *  
 *  buttonRead8() works the same as buttonRead() but works on all 
 *  pins simultaneous. You can give a mask as parameter to decide which 
 *  pins are affected (aka, made high for a short periode) during 
 *  a buttonRead8(). 
 *  
 *  The mask can also be set with setButtonMask(mask). Calling buttonRead8() 
 *  after that will be the same as calling buttonRead8(mask).
 *  
 *  ButtonRead8() can also be used for pins that are input only.
 *  
 *  In this example pin 0 of the PCF8574 (address 0x20) is used to blink a 
 *  LED but at the same time it can be used to toggle the onboard LED of 
 *  the Arduino.
 *  
 *  Pin 1 is also toggle but isn't affected by the buttonRead8();
 *  
 *  NOTE: The button will affect the LED on the same pin. The led will light up 
 *  no matter the set output state when you press the button.
 */

#include <PCF8574.h>
#include <Wire.h>

PCF8574 pcf20(0x20);

const byte onboardLed = 13;
const byte PcfButtonLedPin = 0;
const byte PcfLedPin = 1;

unsigned int blinkMillis;
unsigned int buttonMillis;

void setup() {
  Serial.begin(115200);
  pcf20.begin();
  
  pinMode(onboardLed, OUTPUT);
  
  //As alternative to adding the mask to buttonRead8() every time
  //you can set it once.
  //Without setting a mask buttonRead8() will effect ALL pins.
  //Not a problem when using things like LEDs.
  //pcf20.setButtonMask(_BV(PcfButtonLedPin));
}

void loop() {
  static bool state;
  unsigned int currentMillis = millis();
  
  //Limit button read to 20 times a second
  //Fast enough for most buttons 
  //but this way you don't have a dimmer output because it's blanked during button read
  //a read takes 460us t 16Mhz Arduino and normal I2C speed.
  if(currentMillis - buttonMillis >= 50){
    buttonMillis = currentMillis;
    
    //read all states but only force PcfButtonLedPin HIGH during the 
    //buttonRead8()
    //Alternativly the mask could have been set with setButtonMask().
    //Then the mask can be omitted here. See setup()
    byte inputStates = pcf20.readButton8(_BV(PcfButtonLedPin));
    
    //check the bit of PcfButtonLedPin
    if(state != bitRead(inputStates, PcfButtonLedPin)){
      if(state){
        //toggle the LED
        digitalWrite(onboardLed, !digitalRead(onboardLed));
      }
      state = !state;
    }
  }
  
  //Lets blink the same output
  if(currentMillis - blinkMillis >= 500){
    //Update time
    blinkMillis = currentMillis;
    
    pcf20.toggle(PcfButtonLedPin);
    pcf20.toggle(PcfLedPin);
    Serial.println(pcf20.read8(), BIN);
  }
}