esp-idf/components/esp_adc/Kconfig

89 lines
3.6 KiB
Plaintext

menu "ADC and ADC Calibration"
config ADC_ONESHOT_CTRL_FUNC_IN_IRAM
bool "Place ISR version ADC oneshot mode read function into IRAM"
default n
help
Place ISR version ADC oneshot mode read function into IRAM.
config ADC_CONTINUOUS_ISR_IRAM_SAFE
depends on SOC_ADC_DMA_SUPPORTED
bool "ADC continuous mode driver ISR IRAM-Safe"
default n
select GDMA_ISR_IRAM_SAFE if SOC_ADC_DMA_SUPPORTED && SOC_GDMA_SUPPORTED
help
Ensure the ADC continuous mode ISR is IRAM-Safe. When enabled, the ISR handler
will be available when the cache is disabled.
menu "ADC Calibration Configurations"
depends on IDF_TARGET_ESP32
config ADC_CALI_EFUSE_TP_ENABLE
bool "Use Two Point Values"
default "y"
help
Some ESP32s have Two Point calibration values burned into eFuse BLOCK3.
This option will allow the ADC calibration component to characterize the
ADC-Voltage curve using Two Point values if they are available.
config ADC_CALI_EFUSE_VREF_ENABLE
bool "Use eFuse Vref"
default "y"
help
Some ESP32s have Vref burned into eFuse BLOCK0. This option will allow
the ADC calibration component to characterize the ADC-Voltage curve using
eFuse Vref if it is available.
config ADC_CALI_LUT_ENABLE
bool "Use Lookup Tables"
default "y"
help
This option will allow the ADC calibration component to use Lookup Tables
to correct for non-linear behavior in 11db attenuation. Other attenuations
do not exhibit non-linear behavior hence will not be affected by this option.
endmenu
config ADC_DISABLE_DAC_OUTPUT
depends on SOC_DAC_SUPPORTED
bool "Disable DAC when ADC2 is in use"
default y
help
By default, this is set. The ADC oneshot driver will disable the output of the
corresponding DAC channels:
ESP32: IO25 and IO26
ESP32S2: IO17 and IO18
Disable this option so as to measure the output of DAC by internal ADC, for test usage.
config ADC_CONTINUOUS_FORCE_USE_ADC2_ON_C3_S3
depends on IDF_TARGET_ESP32C3 || IDF_TARGET_ESP32S3
bool "Force use ADC2 continumous mode on ESP32S3 or ESP32C3"
default n
help
On ESP32C3 and ESP32S3, ADC2 Digital Controller is not stable. Therefore,
ADC2 continuous mode is not suggested on ESP32S3 and ESP32C3
If you stick to this, you can enable this option to force use ADC2 under above conditions.
For more details, you can search for errata on espressif website.
config ADC_ONESHOT_FORCE_USE_ADC2_ON_C3
depends on IDF_TARGET_ESP32C3
bool "Force use ADC2 oneshot mode on ESP32C3"
default n
help
On ESP32C3, ADC2 Digital Controller is not stable. Therefore,
ADC2 oneshot mode is not suggested on ESP32C3
If you stick to this, you can enable this option to force use ADC2 under above conditions.
For more details, you can search for errata on espressif website.
config ADC_ENABLE_DEBUG_LOG
bool "Enable ADC debug log"
default n
help
Wether to enable the debug log message for ADC driver.
Note that this option only controls the ADC driver log, will not affect other drivers.
note: This cannot be used in the ADC legacy driver.
endmenu