esp-idf/components/ulp/ulp_riscv/ulp_riscv_utils.c
Sudeep Mohanty 96b152a01f ulp-riscv: ULP RISC-V I2C example gets stuck on esp32s2
This commit fixes an issue where in the ULP RISC-V I2C example causes
a spurious wakeup of the main CPU because of a Trap signal when the ULP
core does not meet the wakeup threshold values. This was due to the fact
that the RTC_CNTL_COCPU_DONE signal was being set before the
RTC_CNTL_COCPU_SHUT_RESET_EN signal which was causing the the ULP RISC-V
core to not reset properly on each cycle.

Closes https://github.com/espressif/esp-idf/issues/10301
2023-01-02 14:24:16 +01:00

48 lines
1.6 KiB
C

// Copyright 2015-2020 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#include "ulp_riscv/ulp_riscv.h"
#include "ulp_riscv/ulp_riscv_utils.h"
void ulp_riscv_rescue_from_monitor(void)
{
/* Rescue RISCV from monitor state. */
CLEAR_PERI_REG_MASK(RTC_CNTL_COCPU_CTRL_REG, RTC_CNTL_COCPU_DONE | RTC_CNTL_COCPU_SHUT_RESET_EN);
}
void ulp_riscv_wakeup_main_processor(void)
{
SET_PERI_REG_MASK(RTC_CNTL_STATE0_REG, RTC_CNTL_SW_CPU_INT);
}
void ulp_riscv_shutdown(void)
{
/* Setting the delay time after RISCV recv `DONE` signal, Ensure that action `RESET` can be executed in time. */
REG_SET_FIELD(RTC_CNTL_COCPU_CTRL_REG, RTC_CNTL_COCPU_SHUT_2_CLK_DIS, 0x3F);
/* Suspends the ulp operation and reset the ULP core. Must be the final operation before going to halt. */
SET_PERI_REG_MASK(RTC_CNTL_COCPU_CTRL_REG, RTC_CNTL_COCPU_DONE | RTC_CNTL_COCPU_SHUT_RESET_EN);
while(1);
}
void ulp_riscv_delay_cycles(uint32_t cycles)
{
uint32_t start = ULP_RISCV_GET_CCOUNT();
while ((ULP_RISCV_GET_CCOUNT() - start) < cycles) {
/* Wait */
}
}