esp-idf/examples/ethernet/iperf/sdkconfig.ci.default_dp83848
Bogdan Kolendovskyy 934f741361 test(examples/ethernet/iperf): Add default configurations for all supported PHYs
Created default configurations to run iperf test on all supported phys and adpated test code appropriately
2024-03-26 11:37:30 +01:00

46 lines
1.4 KiB
Plaintext

# Increase main task stack size
CONFIG_ESP_MAIN_TASK_STACK_SIZE=7168
# Enable filesystem for console commands history storage
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions_example.csv"
CONFIG_PARTITION_TABLE_FILENAME="partitions_example.csv"
# Enable FreeRTOS stats formatting functions, needed for 'tasks' command
CONFIG_FREERTOS_USE_TRACE_FACILITY=y
CONFIG_FREERTOS_USE_STATS_FORMATTING_FUNCTIONS=y
# --------------------------------
# Performance optimization options
# --------------------------------
# `lwIP` and `iperf` tasks have serial dependency to each other (i.e. `iperf` must wait for `lwIP`
# to process the packets). Therefore, you don't gain much performance improvement when running
# multi core mode. On the other hand, IRAM optimizations have greater effect for single core mode.
# Run FreeRTOS only on the first core
CONFIG_FREERTOS_UNICORE=y
# Disable watch dog
CONFIG_ESP_INT_WDT=n
CONFIG_ESP_TASK_WDT_EN=n
# Enable lwIP IRAM optimization
CONFIG_LWIP_IRAM_OPTIMIZATION=y
# Enable Ethernet IRAM optimization
CONFIG_ETH_IRAM_OPTIMIZATION=y
CONFIG_EXAMPLE_USE_INTERNAL_ETHERNET=y
CONFIG_EXAMPLE_ETH_PHY_DP83848=y
CONFIG_EXAMPLE_ETH_MDC_GPIO=23
CONFIG_EXAMPLE_ETH_MDIO_GPIO=18
CONFIG_EXAMPLE_ETH_PHY_RST_GPIO=5
CONFIG_EXAMPLE_ETH_PHY_ADDR=1
CONFIG_ETH_ENABLED=y
CONFIG_ETH_USE_ESP32_EMAC=y
CONFIG_ETH_PHY_INTERFACE_RMII=y
CONFIG_ETH_RMII_CLK_OUTPUT=y
CONFIG_ETH_RMII_CLK_OUT_GPIO=17