esp-idf/examples/zigbee/light_sample/light_switch
likunqiao 8c577cd208 Zigbee example: add rcp and gateway
* provide Zigbee rcp and Zigbee gateway example
 * minor comment fix for light example
2022-01-04 17:46:09 +08:00
..
main Zigbee example: add rcp and gateway 2022-01-04 17:46:09 +08:00
CMakeLists.txt Zigbee: Add light example 2021-11-11 19:03:01 +08:00
partitions.csv Zigbee: Add light example 2021-11-11 19:03:01 +08:00
README.md Zigbee example: add rcp and gateway 2022-01-04 17:46:09 +08:00
sdkconfig.defaults Zigbee: Add light example 2021-11-11 19:03:01 +08:00

Supported Targets ESP32-H2

Light Switch Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This test code shows how to configure Zigbee end device and use it as a light switch

Hardware Required

  • One development board with ESP32-H2 SoC acting as Zigbee end device (loaded with light switch example)
  • A USB cable for power supply and programming
  • Choose another ESP32-H2 as Zigbee coordinator (see light coordinator example)
  • Choose another ESP32-H2 as Zigbee router (see light bulb example)

Configure the project

Before project configuration and build, make sure to set the correct chip target using idf.py set-target esp32h2.

Build and Flash

Build the project, flash it to the board, and start the monitor tool to view the serial output by running idf.py -p PORT flash monitor.

(To exit the serial monitor, type Ctrl-].)

Example Output

As you run the example, you will see the following log:

light switch: I (9423) gpio: GPIO[9]| InputEn: 1| OutputEn: 0| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:2
I (9523) ESP_ZB_SWITCH: status: -1
I (9523) ESP_ZB_SWITCH: Zigbee stack initialized
I (9523) ESP_ZB_SWITCH: Start network steering
I (11263) ESP_ZB_SWITCH: Joined network successfully (Extended PAN ID: f9:54:2d:01:a0:03:f7:84, PAN ID: 0xf5b5)
I (13433) ESP_ZB_SWITCH: Found bulb addr: 0x434a ep: 10
I (16433) ESP_ZB_SWITCH: Send ON/OFF toggle command
I (17663) ESP_ZB_SWITCH: Send ON/OFF toggle command
I (18693) ESP_ZB_SWITCH: Send ON/OFF toggle command
I (19833) ESP_ZB_SWITCH: Send ON/OFF toggle command
I (20753) ESP_ZB_SWITCH: Send ON/OFF toggle command
I (21363) ESP_ZB_SWITCH: Send ON/OFF toggle command

Light Control Functions

  • By toggling the switch button (BOOT) on this board, the LED on the board loaded with the light bulb example will be on and off.

Troubleshooting

For any technical queries, please open an issue on GitHub. We will get back to you soon.