alex/esp-idf
alex/esp-idf
1
0
Fork 0
mirror of https://github.com/espressif/esp-idf.git synced 2024-10-05 20:47:46 -04:00
Code Issues Actions 2 Packages Projects Releases Wiki Activity
d92ac450a2
esp-idf/examples/peripherals/adc/adc2/README.md
Marius Vikhammer 3fd37d0b59 adc: change the way data is formattted in adc_dma_demo 
The way the adc_dma_demo data was formatted caused it go get parsed as markdown syntax.

Changed it be more "human" readable as well as put all ADC examples in a common folder
2021-01-25 04:51:40 +00:00

2.3 KiB
Raw Blame History

Supported Targets ESP32

ADC2 Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

In this example, we use ADC2 to measure the output of DAC.

How to use example

Hardware Required

ESP32 platform

  • A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
  • A USB cable for power supply and programming

We use ADC1_CHANNEL_7 (GPIO27) and DAC_CHANNEL_1 (GPIO25) by default, you need to short the two GPIOs (if you have changed the ADC2 and DAC channel, please refer to Chapter 4.11 of the ESP32 Technical Reference Manual to get the pin number).

ESP32-S2 platform

  • A development board with ESP32S2 SoC
  • A USB cable for power supply and programming

We use ADC1_CHANNEL_7 (GPIO18) and DAC_CHANNEL_1 (GPIO17) by default, you need to short the two GPIOs (if you have changed the ADC2 and DAC channel, please refer to the ESP32S2 Technical Reference Manual to get the pin number).

Configure the project

idf.py menuconfig
  • Set ADC2 and DAC channel in "Example Configuration"

Build and Flash

Build the project and flash it to the board, then run monitor tool to view serial output:

idf.py -p PORT flash monitor

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

Running this example, you will see the following log output on the serial monitor:

ESP32 platform

ADC channel 7 @ GPIO 27, DAC channel 1 @ GPIO 25.
adc2_init...
start conversion.
1: 150
2: 203
3: 250
4: 300
5: 351
6: 400
7: 441
8: 491
9: 547
10: 595
...

ESP32-S2 platform

ADC channel 7 @ GPIO 18, DAC channel 1 @ GPIO 17.
adc2_init...
start conversion.
1: 150
2: 203
3: 250
4: 300
5: 351
6: 400
7: 441
8: 491
9: 547
10: 595
...

Troubleshooting

  • program upload failure

    • Hardware connection is not correct: run idf.py -p PORT monitor, and reboot your board to see if there are any output logs.
    • The baud rate for downloading is too high: lower your baud rate in the menuconfig menu, and try again.

For any technical queries, please open an issue on GitHub. We will get back to you soon.