esp-idf/components/spi_flash/include/esp_flash_spi_init.h
Michael (XIAO Xufeng) 9d9d22c920 esp_flash: deprecate the cs_id member, which is no longer used.
We used to manually specify the CS id. However after the SPI bus lock is
introduced, the lock is responsible to assign the CS lines and provide
the CS id. The esp_flash driver now depends on the ID assigned by the
SPI bus lock, the configuration field is deprecated.
2020-04-17 18:15:33 +08:00

64 lines
2.1 KiB
C

// Copyright 2015-2019 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
//
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#pragma once
#include "hal/spi_types.h"
#include "esp_flash.h"
#ifdef __cplusplus
extern "C" {
#endif
/// Configurations for the SPI Flash to init
typedef struct {
spi_host_device_t host_id; ///< Bus to use
int cs_io_num; ///< GPIO pin to output the CS signal
esp_flash_io_mode_t io_mode; ///< IO mode to read from the Flash
esp_flash_speed_t speed; ///< Speed of the Flash clock
int input_delay_ns; ///< Input delay of the data pins, in ns. Set to 0 if unknown.
int cs_id; ///< @deprecated CS pin (signal) to use
} esp_flash_spi_device_config_t;
/**
* Add a SPI Flash device onto the SPI bus.
*
* The bus should be already initialized by ``spi_bus_initialization``.
*
* @param out_chip Pointer to hold the initialized chip.
* @param config Configuration of the chips to initialize.
*
* @return
* - ESP_ERR_INVALID_ARG: out_chip is NULL, or some field in the config is invalid.
* - ESP_ERR_NO_MEM: failed to allocate memory for the chip structures.
* - ESP_OK: success.
*/
esp_err_t spi_bus_add_flash_device(esp_flash_t **out_chip, const esp_flash_spi_device_config_t *config);
/**
* Remove a SPI Flash device from the SPI bus.
*
* @param chip The flash device to remove.
*
* @return
* - ESP_ERR_INVALID_ARG: The chip is invalid.
* - ESP_OK: success.
*/
esp_err_t spi_bus_remove_flash_device(esp_flash_t *chip);
#ifdef __cplusplus
}
#endif