esp-idf/components/esp_netif/lwip/netif/wlanif.c
David Cermak 5c383d7b73 esp_netif/lwip: Fix deps cycles to "lwip -> esp_netif -> phy-drivers"
Fix dependency tree so that lwip doesn't depend on any specific network
interface component.
Network interface drivers shall depend on esp_netif.
esp_netif shall depend on lwip (but not on any specific interface
driver) -- it optionally depends on vfs and esp_eth (need ethernet
header for L2/bridge mode)
2022-07-20 14:59:07 +02:00

231 lines
6.2 KiB
C

/*
* SPDX-FileCopyrightText: 2001-2004 Swedish Institute of Computer Science
*
* SPDX-License-Identifier: BSD-3-Clause
*
* SPDX-FileContributor: 2015-2022 Espressif Systems (Shanghai) CO LTD
*/
/**
* @file
* Ethernet Interface Skeleton used for WiFi
*
*/
#include <stdio.h>
#include <string.h>
#include "lwip/opt.h"
#include "lwip/pbuf.h"
#include "lwip/snmp.h"
#include "lwip/ethip6.h"
#include "netif/etharp.h"
#include "esp_netif.h"
#include "esp_netif_net_stack.h"
#include "lwip/esp_netif_net_stack.h"
#include "esp_compiler.h"
#include "lwip/esp_pbuf_ref.h"
/**
* In this function, the hardware should be initialized.
* Called from wlanif_input().
*
* @param netif the already initialized lwip network interface structure
* for this wlanif
*/
static void
low_level_init(struct netif *netif)
{
/* set MAC hardware address length */
netif->hwaddr_len = ETHARP_HWADDR_LEN;
/* set MAC hardware address */
/* maximum transfer unit */
netif->mtu = 1500;
/* device capabilities */
/* don't set NETIF_FLAG_ETHARP if this device is not an ethernet one */
netif->flags = NETIF_FLAG_BROADCAST | NETIF_FLAG_ETHARP;
#if ESP_LWIP
#if LWIP_IGMP
netif->flags |= NETIF_FLAG_IGMP;
#endif
#endif
#if ESP_IPV6
#if LWIP_IPV6 && LWIP_IPV6_MLD
netif->flags |= NETIF_FLAG_MLD6;
#endif
#endif
}
/**
* This function should do the actual transmission of the packet. The packet is
* contained in the pbuf that is passed to the function. This pbuf
* might be chained.
*
* @param netif the lwip network interface structure for this wlanif
* @param p the MAC packet to send (e.g. IP packet including MAC addresses and type)
* @return ERR_OK if the packet could be sent
* an err_t value if the packet couldn't be sent
*
* @note Returning ERR_MEM here if a DMA queue of your MAC is full can lead to
* strange results. You might consider waiting for space in the DMA queue
* to become available since the stack doesn't retry to send a packet
* dropped because of memory failure (except for the TCP timers).
*/
static err_t low_level_output(struct netif *netif, struct pbuf *p)
{
esp_netif_t *esp_netif = netif->state;
if (esp_netif == NULL) {
return ERR_IF;
}
struct pbuf *q = p;
esp_err_t ret;
if(q->next == NULL) {
ret = esp_netif_transmit_wrap(esp_netif, q->payload, q->len, q);
} else {
LWIP_DEBUGF(PBUF_DEBUG, ("low_level_output: pbuf is a list, application may has bug"));
q = pbuf_alloc(PBUF_RAW_TX, p->tot_len, PBUF_RAM);
if (q != NULL) {
pbuf_copy(q, p);
} else {
return ERR_MEM;
}
ret = esp_netif_transmit_wrap(esp_netif, q->payload, q->len, q);
pbuf_free(q);
}
if (ret == ESP_OK) {
return ERR_OK;
}
if (ret == ESP_ERR_NO_MEM) {
return ERR_MEM;
}
if (ret == ESP_ERR_INVALID_ARG) {
return ERR_ARG;
}
return ERR_IF;
}
/**
* This function should be called when a packet is ready to be read
* from the interface. It uses the function low_level_input() that
* should handle the actual reception of bytes from the network
* interface. Then the type of the received packet is determined and
* the appropriate input function is called.
*
* @param h lwip network interface structure (struct netif) for this ethernetif
* @param buffer wlan buffer
* @param len length of buffer
* @param l2_buff wlan's L2 buffer pointer
*/
void wlanif_input(void *h, void *buffer, size_t len, void* l2_buff)
{
struct netif * netif = h;
esp_netif_t *esp_netif = netif->state;
struct pbuf *p;
if(unlikely(!buffer || !netif_is_up(netif))) {
if (l2_buff) {
esp_netif_free_rx_buffer(esp_netif, l2_buff);
}
return;
}
#ifdef CONFIG_LWIP_L2_TO_L3_COPY
p = pbuf_alloc(PBUF_RAW, len, PBUF_RAM);
if (p == NULL) {
esp_netif_free_rx_buffer(esp_netif, l2_buff);
return;
}
memcpy(p->payload, buffer, len);
esp_netif_free_rx_buffer(esp_netif, l2_buff);
#else
p = esp_pbuf_allocate(esp_netif, buffer, len, l2_buff);
if (p == NULL) {
esp_netif_free_rx_buffer(esp_netif, l2_buff);
return;
}
#endif
/* full packet send to tcpip_thread to process */
if (unlikely(netif->input(p, netif) != ERR_OK)) {
LWIP_DEBUGF(NETIF_DEBUG, ("wlanif_input: IP input error\n"));
pbuf_free(p);
}
}
/**
* Should be called at the beginning of the program to set up the
* network interface. It calls the function low_level_init() to do the
* actual setup of the hardware.
*
* This function should be passed as a parameter to netif_add().
*
* @param netif the lwip network interface structure for this wlanif
* @return ERR_OK if the loopif is initialized
* ERR_MEM if private data couldn't be allocated
* any other err_t on error
*/
err_t
wlanif_init(struct netif *netif)
{
LWIP_ASSERT("netif != NULL", (netif != NULL));
#if LWIP_NETIF_HOSTNAME
/* Initialize interface hostname */
#if ESP_LWIP
if (esp_netif_get_hostname(esp_netif_get_handle_from_netif_impl(netif), &netif->hostname) != ESP_OK) {
netif->hostname = CONFIG_LWIP_LOCAL_HOSTNAME;
}
#else
netif->hostname = "lwip";
#endif
#endif /* LWIP_NETIF_HOSTNAME */
/*
* Initialize the snmp variables and counters inside the struct netif.
* The last argument should be replaced with your link speed, in units
* of bits per second.
*/
NETIF_INIT_SNMP(netif, snmp_ifType_ethernet_csmacd, 100);
/* We directly use etharp_output() here to save a function call.
* You can instead declare your own function an call etharp_output()
* from it if you have to do some checks before sending (e.g. if link
* is available...) */
netif->output = etharp_output;
#if LWIP_IPV6
netif->output_ip6 = ethip6_output;
#endif /* LWIP_IPV6 */
netif->linkoutput = low_level_output;
/* initialize the hardware */
low_level_init(netif);
return ERR_OK;
}
err_t wlanif_init_sta(struct netif *netif) {
netif->name[0] = 's';
netif->name[1] = 't';
return wlanif_init(netif);
}
err_t wlanif_init_ap(struct netif *netif) {
netif->name[0] = 'a';
netif->name[1] = 'p';
return wlanif_init(netif);
}