esp-idf/components/efuse/esp32c3/include/esp_efuse_rtc_calib.h
KonstantinKondrashov 90f2d3199a secure_boot: Checks secure boot efuses
ESP32 V1 and V2 - protection bits.
ESP32xx V2: revoke bits, protection bits

- refactor efuse component
- adds some APIs for esp32 chips as well as for esp32xx chips
2021-02-23 03:56:21 +08:00

54 lines
1.6 KiB
C

// Copyright 2020 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at",
//
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License
#include <esp_types.h>
#include <esp_err.h>
#ifdef __cplusplus
extern "C" {
#endif
/**
* @brief Get the RTC calibration efuse version
*
* @return Version of the stored efuse
*/
int esp_efuse_rtc_calib_get_ver(void);
/**
* @brief Get the init code in the efuse, for the corresponding attenuation.
*
* @param version Version of the stored efuse
* @param atten Attenuation of the init code
* @return The init code stored in efuse
*/
uint16_t esp_efuse_rtc_calib_get_init_code(int version, int atten);
/**
* @brief Get the calibration digits stored in the efuse, and the corresponding voltage.
*
* @param version Version of the stored efuse
* @param atten Attenuation to use
* @param out_digi Output buffer of the digits
* @param out_vol_mv Output of the voltage, in mV
* @return
* - ESP_ERR_INVALID_ARG: If efuse version or attenuation is invalid
* - ESP_OK: if success
*/
esp_err_t esp_efuse_rtc_calib_get_cal_voltage(int version, int atten, uint32_t* out_digi, uint32_t* out_vol_mv);
#ifdef __cplusplus
}
#endif