esp-idf/examples/bluetooth/bluedroid/ble/gatt_server_service_table

Supported Targets	ESP32	ESP32-C2	ESP32-C3	ESP32-C6	ESP32-H2	ESP32-S3

ESP-IDF Gatt Server Service Table Example

This example shows how to create a GATT service with an attribute table defined in one place. Provided API releases the user from adding attributes one by one as implemented in BLUEDROID. A demo of the other method to create the attribute table is presented in gatt_server_demo.

Please, check this tutorial for more information about this example.

How to Use Example

Before project configuration and build, be sure to set the correct chip target using:

idf.py set-target <chip_name>

Hardware Required

• A development board with ESP32/ESP32-C3/ESP32-H2/ESP32-C2/ESP32-S3 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
• A USB cable for Power supply and programming

See Development Boards for more information about it.

Build and Flash

Run idf.py -p PORT flash monitor to build, flash and monitor the project.

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

I (0) cpu_start: Starting scheduler on APP CPU.
I (512) BTDM_INIT: BT controller compile version [1342a48]
I (522) system_api: Base MAC address is not set
I (522) system_api: read default base MAC address from EFUSE
I (522) phy_init: phy_version 4670,719f9f6,Feb 18 2021,17:07:07
I (942) GATTS_TABLE_DEMO: create attribute table successfully, the number handle = 8

I (942) GATTS_TABLE_DEMO: SERVICE_START_EVT, status 0, service_handle 40
I (962) GATTS_TABLE_DEMO: advertising start successfully

Troubleshooting

For any technical queries, please open an issue on GitHub. We will get back to you soon.