esp-idf/components/soc/include/soc/spi_periph.h
2020-10-28 07:21:29 +08:00

82 lines
2.4 KiB
C

// Copyright 2015-2018 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#pragma once
#include <stdint.h>
#include "sdkconfig.h"
#include "soc/soc.h"
#include "soc/periph_defs.h"
//include soc related (generated) definitions
#include "soc/soc_caps.h"
#include "soc/soc_pins.h"
#include "soc/spi_reg.h"
#include "soc/spi_struct.h"
#include "soc/gpio_sig_map.h"
#if SOC_MEMSPI_IS_INDEPENDENT
#include "soc/spi_mem_struct.h"
#include "soc/spi_mem_reg.h"
#endif
#ifdef __cplusplus
extern "C"
{
#endif
#if CONFIG_IDF_TARGET_ESP32S2
#define SPI_FREAD_DIO 0
#define SPI_FREAD_QIO 0
#define SPI_FWRITE_DIO 0
#define SPI_FWRITE_QIO 0
#endif
/*
Stores a bunch of per-spi-peripheral data.
*/
typedef struct {
const uint8_t spiclk_out; //GPIO mux output signals
const uint8_t spiclk_in;
const uint8_t spid_out;
const uint8_t spiq_out;
const uint8_t spiwp_out;
const uint8_t spihd_out;
const uint8_t spid_in; //GPIO mux input signals
const uint8_t spiq_in;
const uint8_t spiwp_in;
const uint8_t spihd_in;
const uint8_t spics_out[3]; // /CS GPIO output mux signals
const uint8_t spics_in;
const uint8_t spidqs_out;
const uint8_t spicd_out;
const uint8_t spiclk_iomux_pin; //IO pins of IO_MUX muxed signals
const uint8_t spid_iomux_pin;
const uint8_t spiq_iomux_pin;
const uint8_t spiwp_iomux_pin;
const uint8_t spihd_iomux_pin;
const uint8_t spics0_iomux_pin;
const uint8_t irq; //irq source for interrupt mux
const uint8_t irq_dma; //dma irq source for interrupt mux
const periph_module_t module; //peripheral module, for enabling clock etc
const int func; //function number for IOMUX
spi_dev_t *hw; //Pointer to the hardware registers
} spi_signal_conn_t;
extern const spi_signal_conn_t spi_periph_signal[SOC_SPI_PERIPH_NUM];
#ifdef __cplusplus
}
#endif