esp-idf/components/esp_psram/esp32/esp_psram_extram_cache.c

80 lines
2.9 KiB
C

/*
* SPDX-FileCopyrightText: 2015-2023 Espressif Systems (Shanghai) CO LTD
*
* SPDX-License-Identifier: Apache-2.0
*/
#include "soc/dport_reg.h"
#include "esp_attr.h"
#include "esp_psram.h"
#include "esp_private/esp_psram_extram.h"
#if CONFIG_FREERTOS_UNICORE
#define PSRAM_MODE PSRAM_VADDR_MODE_NORMAL
#else
#define PSRAM_MODE PSRAM_VADDR_MODE_LOWHIGH
#endif
/*
Before flushing the cache, if psram is enabled as a memory-mapped thing, we need to write back the data in the cache to the psram first,
otherwise it will get lost. For now, we just read 64/128K of random PSRAM memory to do this.
Note that this routine assumes some unique mapping for the first 2 banks of the PSRAM memory range, as well as the
2 banks after the 2 MiB mark.
*/
void IRAM_ATTR esp_psram_extram_writeback_cache(void)
{
int x;
volatile int i = 0;
volatile uint8_t *psram = (volatile uint8_t*)SOC_EXTRAM_DATA_LOW;
int cache_was_disabled = 0;
if (!esp_psram_is_initialized()) {
return;
}
//We need cache enabled for this to work. Re-enable it if needed; make sure we
//disable it again on exit as well.
if (DPORT_REG_GET_BIT(DPORT_PRO_CACHE_CTRL_REG, DPORT_PRO_CACHE_ENABLE) == 0) {
cache_was_disabled |= (1 << 0);
DPORT_SET_PERI_REG_BITS(DPORT_PRO_CACHE_CTRL_REG, 1, 1, DPORT_PRO_CACHE_ENABLE_S);
}
#ifndef CONFIG_FREERTOS_UNICORE
if (DPORT_REG_GET_BIT(DPORT_APP_CACHE_CTRL_REG, DPORT_APP_CACHE_ENABLE) == 0) {
cache_was_disabled |= (1 << 1);
DPORT_SET_PERI_REG_BITS(DPORT_APP_CACHE_CTRL_REG, 1, 1, DPORT_APP_CACHE_ENABLE_S);
}
#endif
#if (PSRAM_MODE != PSRAM_VADDR_MODE_LOWHIGH)
/*
Single-core and even/odd mode only have 32K of cache evenly distributed over the address lines. We can clear
the cache by just reading 64K worth of cache lines.
*/
for (x = 0; x < 1024 * 64; x += 32) {
i += psram[x];
}
#else
/*
Low/high psram cache mode uses one 32K cache for the lowest 2MiB of SPI flash and another 32K for the highest
2MiB. Clear this by reading from both regions.
Note: this assumes the amount of external RAM is >2M. If it is 2M or less, what this code does is undefined. If
we ever support external RAM chips of 2M or smaller, this may need adjusting.
*/
for (x = 0; x < 1024 * 64; x += 32) {
i += psram[x];
i += psram[x + (1024 * 1024 * 2)];
}
#endif
if (cache_was_disabled & (1 << 0)) {
while (DPORT_GET_PERI_REG_BITS2(DPORT_PRO_DCACHE_DBUG0_REG, DPORT_PRO_CACHE_STATE, DPORT_PRO_CACHE_STATE_S) != 1) ;
DPORT_SET_PERI_REG_BITS(DPORT_PRO_CACHE_CTRL_REG, 1, 0, DPORT_PRO_CACHE_ENABLE_S);
}
#ifndef CONFIG_FREERTOS_UNICORE
if (cache_was_disabled & (1 << 1)) {
while (DPORT_GET_PERI_REG_BITS2(DPORT_APP_DCACHE_DBUG0_REG, DPORT_APP_CACHE_STATE, DPORT_APP_CACHE_STATE_S) != 1);
DPORT_SET_PERI_REG_BITS(DPORT_APP_CACHE_CTRL_REG, 1, 0, DPORT_APP_CACHE_ENABLE_S);
}
#endif
}