da471dfcd1
Updated main examples README to add missing examples folders and Getting Started links Updated wifi/fastscan example README Updated wifi examples README Updated wifi main examples README Added instructions and removed obviousness from examples README Updates on example README in peripherals, system and wifi Updates on example README in peripherals and added wave form pictures on wave_gen example Updates and review on example README Revision on unit style convention Added the getting started link for each supported version Readme review and recommended enhancements Added the default note on the wave form option info Added the ESP32-C3 support information on the temperature sensor example README Added Getting Started information for ESP32-S2 and ESP32-C3 Issue fixed on the supported target on README Resolved merge conflict |
||
|---|---|---|
| .. | ||
| main | ||
| CMakeLists.txt | ||
| README.md | ||
| Supported Targets | ESP32-S2 | ESP32-C3 |
|---|
Temperature Sensor Example
The ESP32-S2 and ESP32-C3 has a built-in temperature sensor. The temperature sensor module contains an 8-bit Sigma-Delta ADC and a temperature offset DAC.
The conversion relationship is the first two columns of the table below. Among them, offset = 0(default) is the main measurement option, and other values are extended measurement options.
| DAC level | offset | measure range(℃) | measure error(℃) |
|---|---|---|---|
| 0 | -2 | 50 ~ 125 | < 3 |
| 1 | -1 | 20 ~ 100 | < 2 |
| 2 | 0 | -10 ~ 80 | < 1 |
| 3 | 1 | -30 ~ 50 | < 2 |
| 4 | 2 | -40 ~ 20 | < 3 |
How to use example
Before project configuration and build, be sure to set the correct chip target using idf.py set-target <chip_name>.
Hardware Required
- A development board with ESP32-S2 or ESP32-C3 SoC (e.g., ESP32-S2-Saola-1, ESP32-S2-DevKitM-1, ESP32-C3-DevKitM-1, etc.)
- A USB cable for power supply and programming
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
Run idf.py -p PORT flash monitor to build, flash and monitor the project.
(To exit the serial monitor, type Ctrl-].)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
I (243) TempSensor: Initializing Temperature sensor
I (243) TempSensor: default dac 2, clk_div 6
I (243) TempSensor: Config temperature range [-10°C ~ 80°C], error < 1°C
I (253) TempSensor: Temperature sensor started
I (1253) TempSensor: Temperature out celsius 27.287399°C
I (2253) TempSensor: Temperature out celsius 26.848801°C
I (3253) TempSensor: Temperature out celsius 26.848801°C
I (4253) TempSensor: Temperature out celsius 27.287399°C
I (5253) TempSensor: Temperature out celsius 27.287399°C
Troubleshooting
For any technical queries, please open an issue on GitHub. We will get back to you soon.