alex/esp-idf
alex/esp-idf
1
0
Fork 0
mirror of https://github.com/espressif/esp-idf.git synced 2024-10-05 20:47:46 -04:00
Code Issues Actions 2 Packages Projects Releases Wiki Activity
453ecbe9f2
esp-idf/examples/peripherals/usb/host/cdc/cdc_acm_host
History
Ivan Grokhotkov e596c84d49 build system: re-add -Wno-format as private flag for some example components
2022-08-03 16:42:47 +04:00
..
main build system: re-add -Wno-format as private flag for some example components 2022-08-03 16:42:47 +04:00
CMakeLists.txt tools: Increase the minimal supported CMake version to 3.16 2022-06-01 06:35:02 +00:00
README.md usb_host: Use USB_Host library calls for desc printing 2022-03-21 18:34:25 +01:00

README.md

Supported Targets ESP32-S2 ESP32-S3

USB CDC-ACM Host Driver Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This example shows how to use the CDC-ACM Host Driver to allow an ESP chip to communicate with a USB CDC-ACM device.

How to use example

Hardware Required

Two ESP boards that have USB-OTG supported. One will act as USB host and the other as USB device.
Connect USB_D+, USB_D-, GND and +5V signals of USB host to USB device.

Pin Assignment

See common pin assignments for USB Device examples from upper level.

Build and Flash

  1. Build and flash tusb_serial_device example to USB device board.
  2. Build this project and flash it to the USB host board, then run monitor tool to view serial output:
idf.py -p PORT flash monitor

(Replace PORT with the name of the serial port to use.)

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Running with dual USB CDC device

USB CDC device example tusb_serial_device example can be configured to act as dual CDC device.

In the device example project, enter command idf.py menuconfig and set Component config->TinyUSB Stack->Communication Device Class (CDC)->CDC channel Count to 2.

This settings also changes device's PID, so EXAMPLE_USB_DEVICE_PID in usb-cdc.c must be changed to 0x4002.

Example Output

After the flashing you should see the output at idf monitor:

...
I (256) USB-CDC: USB Host installed
I (256) USB-CDC: Opening CDC ACM device 0x303A:0x4001
...
Device descriptor is printed here
...
I (1666) USB-CDC: Data received
I (1666) USB-CDC: 0x3ffc4c20   41 54 0d                                          |AT.|
I (2666) USB-CDC: Data received
I (2666) USB-CDC: 0x3ffc4c20   41 54 2b 47 53 4e 0d                              |AT+GSN.|
I (3666) USB-CDC: Setting up line coding
I (3666) USB-CDC: Line Get: Rate: 115200, Stop bits: 0, Parity: 0, Databits: 8
I (3666) USB-CDC: Line Set: Rate: 9600, Stop bits: 1, Parity: 1, Databits: 7
I (3666) USB-CDC: Line Get: Rate: 9600, Stop bits: 1, Parity: 1, Databits: 7
I (3676) Example finished successfully!
...