esp-idf/components/esp_system/port/soc/esp32h2/Kconfig.system
2023-12-11 16:41:52 +08:00

52 lines
1.9 KiB
Plaintext

menu "Brownout Detector"
config ESP_BROWNOUT_DET
bool "Hardware brownout detect & reset"
depends on !IDF_ENV_FPGA
default y
help
The ESP32-H2 has a built-in brownout detector which can detect if the voltage is lower than
a specific value. If this happens, it will reset the chip in order to prevent unintended
behaviour.
choice ESP_BROWNOUT_DET_LVL_SEL
prompt "Brownout voltage level"
depends on ESP_BROWNOUT_DET
default ESP_BROWNOUT_DET_LVL_SEL_0
help
The brownout detector will reset the chip when the supply voltage is approximately
below this level. Note that there may be some variation of brownout voltage level
between each chip.
#The voltage levels here are estimates, more work needs to be done to figure out the exact voltages
#of the brownout threshold levels.
config ESP_BROWNOUT_DET_LVL_SEL_7
bool "2.94V"
config ESP_BROWNOUT_DET_LVL_SEL_6
bool "2.88V"
config ESP_BROWNOUT_DET_LVL_SEL_5
bool "2.83V"
config ESP_BROWNOUT_DET_LVL_SEL_4
bool "2.78V"
config ESP_BROWNOUT_DET_LVL_SEL_3
bool "2.73V"
config ESP_BROWNOUT_DET_LVL_SEL_2
bool "2.67V"
config ESP_BROWNOUT_DET_LVL_SEL_1
bool "2.62V"
config ESP_BROWNOUT_DET_LVL_SEL_0
bool "2.57V"
endchoice
config ESP_BROWNOUT_DET_LVL
int
default 0 if ESP_BROWNOUT_DET_LVL_SEL_0
default 1 if ESP_BROWNOUT_DET_LVL_SEL_1
default 2 if ESP_BROWNOUT_DET_LVL_SEL_2
default 3 if ESP_BROWNOUT_DET_LVL_SEL_3
default 4 if ESP_BROWNOUT_DET_LVL_SEL_4
default 5 if ESP_BROWNOUT_DET_LVL_SEL_5
default 6 if ESP_BROWNOUT_DET_LVL_SEL_6
default 7 if ESP_BROWNOUT_DET_LVL_SEL_7
endmenu