esp-idf/examples/storage/fatfsgen
2021-11-03 13:06:11 +01:00
..
fatfs_image support for generating FATFS on a host 2021-11-03 13:06:11 +01:00
main support for generating FATFS on a host 2021-11-03 13:06:11 +01:00
CMakeLists.txt support for generating FATFS on a host 2021-11-03 13:06:11 +01:00
fatfsgen_example_test.py support for generating FATFS on a host 2021-11-03 13:06:11 +01:00
partitions_example.csv support for generating FATFS on a host 2021-11-03 13:06:11 +01:00
README.md support for generating FATFS on a host 2021-11-03 13:06:11 +01:00
sdkconfig.defaults support for generating FATFS on a host 2021-11-03 13:06:11 +01:00

FATFS partition generation on build example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This example demonstrates how to use the FATFS partition generation tool fatfsgen.py to automatically create a FATFS filesystem image (without wear levelling support) from the contents of a host folder during build, with an option of automatically flashing the created image on invocation of idf.py -p PORT flash. Beware that the minimal required size of the flash is 4 MB. The generated partition does not support wear levelling, so it can be mounted only in read-only mode.

The following gives an overview of the example:

  1. There is a directory fatfs_image from which the FATFS filesystem image will be created.

  2. The function fatfs_create_partition_image is used to specify that a FATFS image should be created during build for the storage partition. For CMake, it is called from the main component's CMakeLists.txt. FLASH_IN_PROJECT specifies that the created image should be flashed on invocation of idf.py -p PORT flash together with app, bootloader, partition table, etc. The image is created on the example's build directory with the output filename storage.bin.

  3. Upon invocation of idf.py -p PORT flash monitor, application loads and finds there is already a valid FATFS filesystem in the storage partition with files same as those in fatfs_image directory. The application is then able to read those files.

How to use example

Build and flash

To run the example, type the following command:

# CMake
idf.py -p PORT flash monitor

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example output

Here is the example's console output:

...
I (322) example: Mounting FAT filesystem
I (332) example: Reading file
I (332) example: Read from file: 'this is test'
I (332) example: Unmounting FAT filesystem
I (342) example: Done

The logic of the example is contained in a single source file, and it should be relatively simple to match points in its execution with the log outputs above.