esp-idf/components/soc/esp32c3/uart_periph.c
Angus Gratton c29d93986d soc: Add initial ESP32-C3 support
From internal commit 7761d6e8
2020-11-30 11:12:56 +11:00

38 lines
1.2 KiB
C

// Copyright 2020 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
//
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#include "soc/uart_periph.h"
/*
Bunch of constants for every UART peripheral: GPIO signals, irqs, hw addr of registers etc
*/
const uart_signal_conn_t uart_periph_signal[SOC_UART_NUM] = {
{
.tx_sig = U0TXD_OUT_IDX,
.rx_sig = U0RXD_IN_IDX,
.rts_sig = U0RTS_OUT_IDX,
.cts_sig = U0CTS_IN_IDX,
.irq = ETS_UART0_INTR_SOURCE,
.module = PERIPH_UART0_MODULE,
},
{
.tx_sig = U1TXD_OUT_IDX,
.rx_sig = U1RXD_IN_IDX,
.rts_sig = U1RTS_OUT_IDX,
.cts_sig = U1CTS_IN_IDX,
.irq = ETS_UART1_INTR_SOURCE,
.module = PERIPH_UART1_MODULE,
}
};