CONFIG_EXAMPLE_FIRMWARE_UPGRADE_URL="FROM_STDIN"
CONFIG_EXAMPLE_SKIP_COMMON_NAME_CHECK=y
CONFIG_SECURE_FLASH_ENC_ENABLED=y
CONFIG_SECURE_FLASH_ENCRYPTION_MODE_DEVELOPMENT=y
CONFIG_SECURE_BOOT_ALLOW_ROM_BASIC=y
CONFIG_SECURE_BOOT_ALLOW_JTAG=y
CONFIG_SECURE_FLASH_UART_BOOTLOADER_ALLOW_ENC=y
CONFIG_SECURE_FLASH_UART_BOOTLOADER_ALLOW_DEC=y
CONFIG_SECURE_FLASH_UART_BOOTLOADER_ALLOW_CACHE=y
CONFIG_SECURE_FLASH_REQUIRE_ALREADY_ENABLED=y
CONFIG_PARTITION_TABLE_OFFSET=0x9000
CONFIG_EXAMPLE_CONNECT_ETHERNET=y
CONFIG_EXAMPLE_CONNECT_WIFI=n
CONFIG_EXAMPLE_USE_INTERNAL_ETHERNET=y
CONFIG_EXAMPLE_ETH_PHY_IP101=y
CONFIG_EXAMPLE_ETH_MDC_GPIO=23
CONFIG_EXAMPLE_ETH_MDIO_GPIO=18
CONFIG_EXAMPLE_ETH_PHY_RST_GPIO=5
CONFIG_EXAMPLE_ETH_PHY_ADDR=1
CONFIG_EXAMPLE_CONNECT_IPV6=y
# This is required for nvs encryption (which is enabled by default with flash encryption)
CONFIG_PARTITION_TABLE_TWO_OTA_ENCRYPTED_NVS=y