#
# Partition Table
#
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions.csv"

#
# Serial flasher config
#
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHFREQ_80M=y

# Override some defaults so BT stack is enabled
# by default in this example
CONFIG_BT_ENABLED=y
CONFIG_BT_CTRL_ESP32C3=y
CONFIG_BT_CTRL_SCAN_DUPL_TYPE_DATA_DEVICE=y
CONFIG_BT_CTRL_BLE_MESH_SCAN_DUPL_EN=y
CONFIG_BT_GATTS_SEND_SERVICE_CHANGE_MANUAL=y
CONFIG_BT_BTU_TASK_STACK_SIZE=4512
CONFIG_BT_BLE_42_FEATURES_SUPPORTED=y

# Override some defaults of ESP BLE Mesh
CONFIG_BLE_MESH=y
CONFIG_BLE_MESH_NODE=y
CONFIG_BLE_MESH_PB_GATT=y
CONFIG_BLE_MESH_TX_SEG_MSG_COUNT=10
CONFIG_BLE_MESH_RX_SEG_MSG_COUNT=10
CONFIG_BLE_MESH_SETTINGS=y
CONFIG_BLE_MESH_SUBNET_COUNT=5
CONFIG_BLE_MESH_APP_KEY_COUNT=5
CONFIG_BLE_MESH_MODEL_KEY_COUNT=5
CONFIG_BLE_MESH_MODEL_GROUP_COUNT=5
CONFIG_BLE_MESH_MSG_CACHE_SIZE=20
CONFIG_BLE_MESH_ADV_BUF_COUNT=256

#
# light driver config
#
CONFIG_LIGHT_GPIO_RED=4
CONFIG_LIGHT_GPIO_GREEN=5
CONFIG_LIGHT_GPIO_BLUE=6
CONFIG_LIGHT_GPIO_COLD=7
CONFIG_LIGHT_GPIO_WARM=10
# end of light driver config