# Override some defaults so BT stack is enabled
# by default in this example
CONFIG_BT_ENABLED=y
CONFIG_BTDM_CTRL_MODE_BLE_ONLY=y
CONFIG_BTDM_CTRL_MODE_BR_EDR_ONLY=n
CONFIG_BTDM_CTRL_MODE_BTDM=n
CONFIG_BTDM_MODEM_SLEEP=n
CONFIG_BTDM_SCAN_DUPL_TYPE_DATA_DEVICE=y
CONFIG_BTDM_BLE_MESH_SCAN_DUPL_EN=y
CONFIG_BT_GATTS_SEND_SERVICE_CHANGE_MANUAL=y
CONFIG_BT_BTU_TASK_STACK_SIZE=4512

# Override some defaults of ESP BLE Mesh
CONFIG_BLE_MESH=y
CONFIG_BLE_MESH_NODE=y
CONFIG_BLE_MESH_PB_GATT=y
CONFIG_BLE_MESH_TX_SEG_MSG_COUNT=3
CONFIG_BLE_MESH_RX_SEG_MSG_COUNT=3
CONFIG_BLE_MESH_CFG_CLI=y
CONFIG_BLE_MESH_GENERIC_ONOFF_CLI=y
CONFIG_BLE_MESH_PROVISIONER=y
CONFIG_BLE_MESH_PROVISIONER_RECV_HB=y
CONFIG_BLE_MESH_PROVISIONER_RECV_HB_FILTER_SIZE=3
CONFIG_BLE_MESH_SELF_TEST=y
CONFIG_BLE_MESH_TEST_AUTO_ENTER_NETWORK=y
CONFIG_BLE_MESH_WAIT_FOR_PROV_MAX_DEV_NUM=80
CONFIG_BLE_MESH_MAX_PROV_NODES=80

# partitions
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_FILENAME="partitions.csv"
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"