1. Add STA checks during STA PMF operations
2. Fix WPA2-Ent issue with Open AP
3. Skip WPA-TKIP profile if PMF is required
4. Skip & clear Supplicant PMK Cache with mismatching AP config
* changing dependencies from unity->cmock
* added component.mk and Makefile.projbuild
* ignore test dir in gen_esp_err_to_name.py
* added some brief introduction of CMock in IDF
H/W decryption of Mgmt frames was disabled for PMF and done through
S/W. If ESPNOW packets go through this path, it affects backward
compatibility since method of decrypting Mgmt packets is different in H/W.
To address PMF + ESPNOW Co-existance, CCMP decryption method is modified
for ESPNOW packets so that they can be decrypted correctly. Since Tx
of ESPNOW packets can still be done in H/W alongside PMF, no change
required in encryption method in S/W.
Co-Authored-By: Nachiket Kukade <nachiket.kukade@espressif.com>
Co-Authored-By: zhangyanjiao <zhangyanjiao@espressif.com>
Co-Authored-By: kapil.gupta <kapil.gupta@espressif.com>
wpa_supplicant: add support for PAP, MS-CHAP and CHAP as Phase 2 algorithms for TTLS alongside MS-CHAPv2
Closes FCS-361
See merge request espressif/esp-idf!8816
Add following changes as part of this:
1. EAP client will crash during validation of key size when CA
certs and keys not present. Add changes to validate it first.
2. Free memory allocated in TLS context
1. If Device is connected to AP in WPA3-PSK mode, AP switching
security to WPA2-PSK causes connection failures even after reset.
Fix is to not store WPA3's PMK in NVS for caching.
2. AP switching back to WPA3 causes even more connection failures.
This is due to device not clearing Supplicant level PMK Cache when
it is no longer valid. Fix is to clear the Cache when 4-way handshake
fails and to check Key Mgmt of Cache before using.
3. When AP switches from WPA3 to WPA2, device's PMF config in
Supplicant remains enabled. This may cause failures during
4-way handshake. So clear PMF config in when PMF is no longer used.
WPS can send multiple AP credentials, while existing implementation
will only use the first credentials which could be for the 5G band.
Fix this by passing these credentials to the App and attempting
to connect using each of those. Older Apps will remain compatible
without breaking WPS, but the issue will remain.
Curretly wpa_supplicant uses internal APIs for RSA operations
which internally uses lots of big num operations.
Big num operations are CPU expensive and can take a lot of time
which can cause watchdog timer to tigger.
This can be optimize by using mbedtls APIs which uses
hardware blocks for big num operations.
To fix this, write new crypto_mbedtls-rsa.c which has APIs
similar to crypto_internal-rsa.c but uses mbedtls APIs.
In case of wrong passpharse, AP will keep on sending 1/4 multiple
times which may take around 10 secs to disconnect and detect
wrong password event.
Add changes to reject EAPOL1 after 3 consecutive reception
Some AP's keep NULL-padding at the end of some variable length WPS
Attributes. This is not as par the WPS2.0 specs, but to avoid interop
issues, ignore the padding by reducing the attribute length by 1.
1. Buffers for SAE messages are not freed after the handshake.
This causes memory leak, free buffers after SAE handshake.
2. SAE global data is not freed until the next WPA3 connection
takes place, holding up heap space without reason. Free this
data after SAE handshake is complete or event fails.
3. Update wifi lib which includes memory leak fix during BIP
encryption/decryption operations.
Add files required for DPP feature from upstream.
These file expose the functionality to create DPP packets.
Ported crypto layer from openssl to mbedtls.
Interfacing to use these API will be added in seperate commit
This is a regression from earlier commit related to TLSV12 which used
sha functions that are currently declared static.
Solution: Follow upstream code structure and resolve the errors.
Problem:
mbedtls_ctr_drbg_context was initialized in crypto_ec_point_mul. This
was okay in releases before 2.16.4 as entropy_len used to get set to
MBEDTLS_CTR_DRBG_ENTROPY_LEN in function mbedtls_ctr_drbg_seed. The
function is now changed to set the length to
MBEDTLS_CTR_DRBG_ENTROPY_LEN if previous length is 0 and hence the bug.
Solution:
Initialize mbedtls_ctr_drbg_context in crypto_ec_point_mul.
Activated AES, RSA and SHA hardware acceleration for esp32s2 and enabled related unit tests.
Updated with changes made for ESP32 from 0a04034, 961f59f and caea288.
Added performance targets for esp32s2beta
Closes IDF-757
1. Add changes in 4-way handshake path to allow SAE key mgmt.
2. Support for configuring WAP3 at init time, added Kconfig option.
3. Handle and propagate error conditions properly.
4. Link changes from WiFi library.
Under WPA3-Personal, SAE authentication is used to derive PMK
which is more secure and immune to offline dictionary attacks.
1. Add modules to generate SAE commit/confirm for the handshake
2. Add modules that build and parse SAE data in Auth frames
3. Add WPA3 association and key mgmt definitions
4. Invert y-bit while solving for ECC co-ordinate -
Once an X co-ordinate is obtained, solving for Y co-ordinate
using an elliptical curve equation results in 2 possible values,
Y and (P - Y), where p is the prime number. The co-ordinates are
used for deriving keys in SAE handshake. As par the 802.11 spec
if LSB of X is same as LSB of Y then Y is chosen, (P - Y) otherwise.
This is not what is implemented, so fix this behavior to obtain the
correct Y co-ordinate.
This change ports SAE(Simultaneous Authentication of Equals)
feature from wpa_supplicant and makes it work with mbedtls
crypto APIs. Currently only group 19 is supported. A sample
SAE handshake is included in the testcase. Other minor
changes for DH groups are also included.
1. Add CCMP, AES crypto modules for unicast protected Mgmt frames
2. Add support for computing SHA256 MIC on Bcast Mgmt frames
3. Add support for storing iGTK during 4-way handshake.
4. Provide APIs to MLME for utilizing the SW crypto modules
5. Link PMF changes from WiFi library submodule
1. Add APIs for configuring PMF through set config.
2. Map Supplicant and Wifi Cipher types.
3. Add support for PMF negotiation while generating RSN IE.
1) Added PMK caching module from wpa_supplicant.
2) Modified wpa_sm to
a) Add entry to PMK cache when first time associated to an AP.
b) Maintain entry across the associations.
c) Clear current PMKSA when deauth happens.
d) Search for an entry when re-associating to the same AP and
set it as current PMKSA
e) Wait for msg 1/4 from AP instead of starting EAP authentication.
f) Check PMKID in msg 1 with current PMKSA/cache.
g) Use the cached PMK to complete 4-way handshake.
3) Remove config_bss callback as it was redundant and used to cause
problems for PMK caching flow.
Closes IDF-969
When running with wpa debug prints enabled data/key hexdumps are
printed to the log in a really verbose format (one byte per line).
Make these printouts more compact. 16 bytes per line.
Rename and add multiple kconfig compiler options. New compiler options
COMPILER_OPTIMIZATION_PERF and COMPILER_OPTIMIZATION_NONE have been added.
Optimize "Debug" and "Release" options to "Default" and "Size" respectively.
This commit also does the following:
- The COMPILER_OPTIMIZATION_PERF option introduced multiple bug.
This commit fixes those bugs.
- build.yml also updated to test for the new optimization options.
EAP reauth frames are dropped at various stages due to current
implementation of WPA2 ENT states and EAP SM init/deinit logic.
Route EAPOL frames based on EAP pkt type and maintain EAP SM
to facilitate EAP re-authentication process.
The full fix for the change includes a fix from wifi library
(commit - 36f99df849214fbf9b0d15e58554632a568e05aa).
Some APs incorrectly advertize newer WPS2.0 config method bits
without setting bits for the corresponding older methods. This
results in failures during 8-way handshake. Add a workaround to
relax this check so that WPS handshake can proceed.
A lot of internally used crypto headers are publicly includeable
in user projects. This leads to bug reports when these headers
are incorrectly used or the API's are not used as intended.
Move all crypto headers into private crypto src folder, also move
crypto_ops into Supplicant to remove dependecy on crypto headers.
Closes IDF-476
wpa_supplicant is using MbedTLS API's for crypto algorithms. For
calling them a duplicate set of modules is maintained prepended
with 'fast_'. Remove these and use flag USE_MBEDTLS_CRYPTO
instead to separate modules calling MbedTLS API's from native
implementation.
Move supplicant to idf and do following refactoring:
1. Make the folder structure consitent with supplicant upstream
2. Remove duplicated header files and minimize the public header files
3. Refactor for WiFi/supplicant interfaces
Do not include bootloader in flash target when secure boot is enabled.
Emit signing warning on all cases where signed apps are enabled (secure
boot and signed images)
Follow convention of capital letters for SECURE_BOOT_SIGNING_KEY
variable, since it is
relevant to other components, not just bootloader.
Pass signing key and verification key via config, not requiring
bootloader to know parent app dir.
Misc. variables name corrections
