1. Fixed crash after controller disable and re-enable
2. Fixed the crash caused by processing the HCI_Read_Remote_Extented_Features command in the non-connected state
3. Fixed disconnection due to not handling lmp_unsniff_req in LC_WAIT_SNIFF_SUB_RSP state
4. Fixed crash caused by supervision timeout greater than sniff interval
Closes https://github.com/espressif/esp-idf/issues/11164
Closes https://github.com/espressif/esp-idf/issues/10835
The remaining 4 kB had been reserved for storing RF calibration and
BT stack state since 4e092be6. However, these features never got
implemented. If we ever need to place RF related data into RTC slow
memory, we can do this by creating a variable with RTC_NOINIT_ATTR
instead.
https://github.com/espressif/esp-idf/issues/6515
This commit adds a workaround for the TWAI listen only mode errata which is
present on the ESP32, ESP32-S2, ESP32-S3, and ESP32-C3. twai_get_status_info()
has also been updated to account for the fact that TEC/REC are frozen in
listen only mode.
Errata Description:
When the TWAI controller is put into listen only mode, it should not influence
the TWAI bus in any way (i.e., should never send a dominant bit). However,
on the targets listed above, the TWAI controller will send dominant bits in an
error frame (i.e., active error frame), even if the controller is set to listen
only mode.
Workaround:
We can force the TWAI controller into the error passive state on startup (by
setting the REC to >= 128). Since the TEC/REC are frozen in listen only mode,
the TWAI controller will remain error passive and only send recessive bits
(i.e., passive error frames), thus will not influence the TWAI bus.
Closes https://github.com/espressif/esp-idf/issues/9157
1. fix softap beacon memory leak issue.
2. fix esp wifi sta get ap info does not return connected ssid issue.
3. update inactive timer when recv ps-poll or success send data.
- Add config to set duplicate scan list refresh period
- overwrite the oldest device infor if the list is full
- Fixed duplicate scan period is not accurate
- Change default TX power to 9 dBm
- Fixed disconnect reason 0x1f (unspecified error)
- Fixed connection timeout due to terminate ind has not been acknowledged
- Fixed some memory was not released after bluetooth controller initialization failed on ESP32
