Commit Graph

5 Commits

Author SHA1 Message Date
Konstantin Kondrashov
399d2d2605 all: Using xxx_periph.h
Using xxx_periph.h in whole IDF instead of xxx_reg.h, xxx_struct.h, xxx_channel.h ... .

Cleaned up header files from unnecessary headers (releated to soc/... headers).
2019-06-03 14:15:08 +08:00
chenjianqiang
a0beff99d2 bugfix(psram): fix psram size acquisition method
1. Use BIT[7:5] of EID to determine psram size
2. Add ID support for 16Mbit psram
3. Remove module reset on SPI1
4. Confirmed with the vendor that only the old 32Mbit psram need special clock timing. For other psram chips, we should use standard QPI mode.
2018-11-28 17:05:37 +08:00
chenjianqiang
a10b7e892c bugfix(psram): fix psram driver
1. remove use EID to distinguish psram voltage
2. 1V8 64Mbit psram and 3V3 64Mbit psram use the same psram driver(standard spi interface)
3. set cs hold time register as 1
2018-10-08 19:55:13 +08:00
Wangjialin
6e9c59bfc3 feature(psram): add support for 64MBit psram of 1.8v and 3.3v.
1. Add reading psram EID.
2. Configure different clock mode for different EID.
3. add API to get psram size and voltage.
4. Remove unnecessary VSPI claim.

For 32MBit@1.8V and 64MBit@3.3V psram, there should be 2 extra clock cycles after CS get high level.
For 64MBit@1.8 psram, we can just use standard SPI protocol to drive the psram. We also need to increase the HOLD time for CS in this case.

EID for psram:
32MBit 1.8v: 0x20
64MBit 1.8v: 0x26
64MBit 3.3v: 0x46
2018-07-10 14:24:59 +08:00
Jeroen Domburg
34372a091c Add initial SPI RAM support. This adds support for an ESP-PSRAM32 chip connected to the default flash pins and GPIO 16 and 17. The RAM is mapped to address 0x3F800000, but otherwise ignored by esp-idf as of yet. 2017-09-04 12:05:49 +08:00