essl_spi: fix wrong dummy cycle under quad spi mode ant add a test to verify spi quad mod
Closes IDF-5182 and IDF-5181
See merge request espressif/esp-idf!18680
1.The dummy_bits is set to 4 in ESP32C3/C2, therefore, the data transmission started too early.This commit fix this issue by changing dummy_bits to 8.
2.Put the spi command the spi defintion in spi_types.h
3.Put the function which get spi command or dummy bits in spi_ll.h
Internally, disable usb serial jtag DP pin's pullup when calling gpio_ll_pullup_dis and rtcio_ll_pullup_disable
At usb serial jtag setup/install, re-enable DP pin's pullup
Closes https://github.com/espressif/esp-idf/issues/9495
Closes: https://github.com/espressif/esp-idf/issues/9208
When I2S is configured into different modes, the slot sequence varies.
This commit updates slot sequence tables and corresponding descriptions
in (both code and programming guide).
All gpio hal and ll functions input arguments gpio_num_t are changed to uint32_t type.
Validation of gpio num should be guaranteed from the driver layer.
When ESP32-C2 is paired with a 26 MHz XTAL, the systimer tick
frequency becomes equal to 26 / 2.5 = 10.4 MHz. Previously we always
assumed that systimer tick frequency is integer (and 1 MHz * power of
two, above that!).
This commit introduces a new LL macro, SYSTIMER_LL_TICKS_PER_US_DIV.
It should be set in such a way that:
1. SYSTIMER_LL_TICKS_PER_US / SYSTIMER_LL_TICKS_PER_US_DIV equals the
actual systimer tick frequency,
2. and SYSTIMER_LL_TICKS_PER_US is integer.
For ESP32-C2 this means that SYSTIMER_LL_TICKS_PER_US = 52 and
SYSTIMER_LL_TICKS_PER_US_DIV = 5.
This introduced two possible issues:
1. Overflow when multiplying systimer counter by 5
- Should not be an issue, since systimer counter is 52-bit, so
counter * 5 is no more than 55-bit.
2. The code needs to perform:
- divide by 5: when converting from microseconds to ticks
- divide by 52: when converting from ticks to microseconds
The latter potentially introduces a performance issue for the
esp_timer_get_time function.
When creating G0 layer, some regi2c_*.h headers were moved out from
esp_hw_support (G1) to soc (G0). In order to be consistent with that change,
move all the remaining regi2c_*.h headers to soc too.
