1. Fixed not update phy according to country code.
2. Fixed crashed when esp_wifi_set_ant_gpio() called
3. Fixed a bug when ftm used with ps enabled
4. Fixed a potential issue to allocate PSRAM to wifi stack where internal RAM is required
5. Fixed potential fail to scan AP after receiving disassoc/deauth from AP on esp32s2
y
1. Clear old keys before going for new connection
2. Fix deep sleep can't reconnect to ap when pmf enable
3. Fix some ap will ignore auth when rx deauth for some time
4. Support force ht40 for espnow & 80211_tx
5. WAPI: Key mgmt type compability issue
6. Update wifi header file
7. Fix espnow recv unencrypted packets issue
1 Bugfix for wrong config of static txbuf
2 fix bug that qos data will update BA SSN
3 reset beacon timeout timer
4 Bugfix for close sniffer mode when wifi stop
5 update wifi header files
The following functions are only defined when CONFIG_PM_ENABLE is defined:
- wifi_apb80m_request()
- wifi_apb80m_release()
This commit makes their linker script mapping statements also dependent on CONFIG_PM_ENABLE
thus fixing some linker errors when CONFIG_PM_ENABLE is disabled.
1. Rename MACROs SYSTEM_WIFI_RST_EN register bit fields to be more recognizable
2. reset Bluetooth baseband and MAC bits to fix the issue of task watchdog triggered during controller initialization due to invalid hardware state
Prior to this change "esp_wifi_clear_default_wifi_driver_and_handlers"
will not remove netif pointer from table when both AP and STA interfaces were
created and destroying default wifi interfaces is done in unfortunate
order. As a result there is dangling pointer left and it may cause crash in
later code (i.e. when esp_wifi_stop() is called).
While using esp_wifi_set_config, flag pmf_capable defaults to 0.
Users may not bother to enable it, which prevents connection to a
WPA3 AP. Or the AP may reset into WPA3 mode failing the re-connection.
To ensure better security, deprecate the pmf_capable flag and set it to
true internally.
Update wifi lib with below fixes -
1. In FTM Responder, add session timer for cleanup, also remove
unnecessary mutex locks
2. In FTM Responder, fix incorrect print in case of failure
while setting up the SofTAP
2. In FTM Initiator, increase FTM Request response timeout to
avoid failures in noisy environments
3. In FTM Initiator, abort for high start delta time, also fix
timeout issue in ASAP mode
