- `protocomm` depends on a config option `CONFIG_WIFI_PROV_BLE_FORCE_ENCRYPTION`
from `wifi_provisioning`; however, a lower layer component (`protocomm`) should
not have any `#ifdef` guard dependent on an upper layer component (`wifi_provisioning`).
- Added a new `ble_link_encryption` flag in `protocomm_ble_config_t` to manage the same
Closes https://github.com/espressif/esp-idf/issues/9443
Currently loading of esp32s3 ROM ELF symbols fails with
"Cannot access memory at address 0x3ff194ad". Let's perform
add-symbol-file after connection to the target.
Signed-off-by: Frantisek Hrbata <frantisek.hrbata@espressif.com>
For efuse example test, we set CONFIG_SECURE_ENABLE_SECURE_ROM_DL_MODE=y
by default because in the python test we expect secure boot is in RELEASE mode
This commit fixes an issue where paths on Windows are case insensitive, for instance when setting the build folder its name would be converted to lowercase.
The culprit is our realpath() function, that was calling os.path.normcase() internally, since we are removing that call it makes sense to just remove the function entirely and call os.path.realpath() wherever necessary.
Closes https://github.com/espressif/esp-idf/issues/10282
1. Corrected format
2. Fixed double free of memory issue in case of disconnection
3. Updated sdkconfig.default file to have correct value for
COC_MAX_NUM configuration setting
By default, the driver will reset the GPIO used by the MCPWM capture
channel at exit. But in some special use cases, the same gpio may also
be used by another device, which shares the same gpio configuration,
resetting the gpio is not expected.
Closes https://github.com/espressif/esp-idf/issues/10327
- GCM operation in mbedtls used ECB, which calculated only 16 bytes of data each time.
- Therefore, when processing a large amount of data, it is necessary to frequently set hardware acceleration calculations,
- which could not make good use of the AES DMA function to improve efficiency.
- Hence, GCM implementation is replaced with CTR-based calculation which utilizes AES DMA to improve efficiency.
usb_host_transfer_submit_control() uses the incorrect bmRequestType direction
flag. Therefore, when doing a transfer check, all transfers were mistakenly
treated as OUT transfers (only affects transfer check and not actual transfer).
This commit fixes a race condtion bug with usb_dwc_hal_chan_request_halt()
where a channel the channel is halted if it has just completed a transfer
(i.e., finished processing a QTD with the "HOC" flag set) but the channel is
still pending interrupt handling. In this case...
- usb_dwc_hal_chan_request_halt() would simply read the channel's underlying
register, determine it is not active, not set the "halt_requested" flag, and
simply return true.
- The caller assumes of usb_dwc_hal_chan_request_halt() will assume that the
channel has halted, and may proceed to reconfigure the pipe/port
- When usb_dwc_hal_chan_decode_intr() comes to process the pending interrupt
it will simply return USB_DWC_HAL_CHAN_EVENT_CPLT not knowing a halt has been
requested.
This commit updates the implementation of usb_dwc_hal_chan_request_halt() so
that a halt is properly requested even if the underlying channel has already
physically halted.
